Original Pine-Sol® Multi-Surface Cleaner

If symptoms develop move victim to fresh air. If symptoms persist, obtain medical attention.

Flush with cool water. Wash with soap and water. Obtain medical attention if irritation persists.

If in eyes: Rinse with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical attention.

Symptoms: Causes serious eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred vision.

Do not induce vomiting. If vomiting occurs naturally, have victim lean forward to reduce risk of aspiration. Never give anything by mouth if victim is unconscious or is convulsing. Obtain medical attention.

Treat for surrounding material.

Do not use water jet as an extinguisher, as this will spread the fire.

During fire, gases hazardous to health may be formed.

Move containers from fire area if you can do it without risk.

Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid discharge into drains, water courses or onto the ground. Do not discharge into lakes, streams, ponds or public waters.

Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: vermiculite, dry sand or earth, absorbent material (e.g. cloth, fleece)

Avoid contact with skin and eyes. Avoid breathing mist or vapor. Do not taste or swallow. Use good industrial hygiene practices in handling this material. When using do not eat or drink. Wash contaminated clothing before reuse. Wash thoroughly after handling.

Keep out of reach of children. Keep containers tightly closed in a dry, cool and well-ventilated place.

When using do not eat or drink. Wash contaminated clothing before reuse. Wash thoroughly after handling.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Provide eyewash station. Provide adequate local exhaust ventilation to maintain worker exposure below exposure limits. Ensure adequate ventilation.

Wear appropriate chemical resistant gloves.

Wear chemical goggles.

Where exposure guideline levels may be exceeded, use an approved NIOSH respirator. Respirator should be selected by and used under the direction of a trained health and safety professional following requirements found in OSHA's respirator standard (29 CFR 1910.134), CAN/CSA-Z94.4 and ANSI's standard for respiratory protection (Z88.2).

Wear appropriate chemical resistant clothing.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

No dangerous reaction known under conditions of normal use.

Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. Do not mix with other chemicals.

Strong oxidizing agents.

May include and are not limited to: Oxides of carbon.