Meguin Schmierfett C2S

Normally not necessary. Remove person from danger area. Supply person with fresh air and consult doctor according to symptoms.

Remove polluted, soaked clothing immediately, wash thoroughly with plenty of water and soap, in case of irritation of the skin (flare), consult a doctor.

Symptoms: Drying of the skin. With long-term contact: Irritation of the skin.

Remove contact lenses. Wash thoroughly for several minutes using copious water. Seek medical help if necessary.

Do not induce vomiting. Consult doctor immediately.

CO2, Foam, Dry extinguisher

High volume water jet

In case of fire the following can develop: Oxides of carbon, Oxides of nitrogen, Oxides of sulphur. Hot product gives off combustible vapours.

According to size of fire Full protection, if necessary.

Leave the danger zone if possible, use existing emergency plans if necessary. Ensure sufficient supply of air.

If leakage occurs, dam up. Resolve leaks if this possible without risk.

Soak up with absorbent material and dispose of according to Section 13. Or: Pick up mechanically and dispose of according to Section 13.

Materials: absorbent material (e.g. universal binding agent)

Ensure good ventilation. Keep away from sources of ignition - Do not smoke. Take measures against electrostatic charging, if appropriate. Do not heat to temperatures close to flash point.

Not to be stored in gangways or stair wells. Store product closed and only in original packing.

General hygiene measures for the handling of chemicals are applicable. Wash hands before breaks and at end of work. Keep away from food, drink and animal feedingstuffs. Remove contaminated clothing and protective equipment before entering areas in which food is consumed. Eating, drinking, smoking, as well as food-storage, is prohibited in work-room.

Keep away from sources of ignition - Do not smoke. Take measures against electrostatic charging, if appropriate. Do not heat to temperatures close to flash point.

Ensure good ventilation. This can be achieved by local suction or general air extraction. If this is insufficient to maintain the concentration under the WEL or AGW values, suitable breathing protection should be worn. Applies only if maximum permissible exposure values are listed here.

Recommended Protective nitrile gloves (EN ISO 374). Minimum layer thickness in mm: >= 0,38 Permeation time (penetration time) in minutes: >= 480. Protective hand cream recommended. The breakthrough times determined in accordance with EN 16523-1 were not obtained under practical conditions. The recommended maximum wearing time is 50% of breakthrough time. Additional information on hand protection - No tests have been performed. In the case of mixtures, the selection has been made according to the knowledge available and the information about the contents. Selection of materials derived from glove manufacturer's indications. Final selection of glove material must be made taking the breakthrough times, permeation rates and degradation into account. Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer to manufacturer. In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use. The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.

Tight fitting protective goggles with side protection (EN 166).

Normally not necessary.

Protective working garments (e.g. safety shoes EN ISO 20345, long-sleeved protective working garments).

No information available at present.

Stable with proper storage and handling.

The product has not been tested.

No dangerous reactions are known.

Protect from humidity.

Strong oxidizing agents.

No decomposition when used as directed.