PHENOXY RESIN PKHW-34

Move to fresh air. Call a physician if symptoms develop or persist.

Remove contaminated clothing immediately and wash skin with soap and water. In case of eczema or other skin disorders: Seek medical attention and take along these instructions.

Symptoms: Skin irritation. May cause redness and pain.

Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention immediately.

Symptoms: Causes serious eye damage. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. Permanent eye damage including blindness could result.

Rinse mouth. Get medical attention if symptoms occur.

Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).

Do not use water jet as an extinguisher, as this will spread the fire.

During fire, gases hazardous to health may be formed.

Move containers from fire area if you can do so without risk.

Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Ensure adequate ventilation.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Use a non-combustible material like vermiculite, sand or earth to soak up the product and place into a container for later disposal. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid release to the environment. Environmental manager must be informed of all major releases.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: absorbent material (e.g. cloth, fleece)

Wear appropriate personal protective equipment. Avoid contact with eyes, skin, and clothing. Use with adequate ventilation. Avoid release to the environment. Observe good industrial hygiene practices.

Keep container tightly closed. Store in a well-ventilated place. Store in a cool place. Store away from incompatible materials (see section 10 of the SDS).

Observe good industrial hygiene practices.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level.

Wear appropriate chemical resistant gloves. PVC gloves are recommended.

Wear safety glasses with side shields (or goggles).

In case of insufficient ventilation, wear suitable respiratory equipment. NIOSH-approved, organic vapour/particulate respirator with a minimum of APF 10.

Wear suitable protective clothing.

Avoid release to the environment. Environmental manager must be informed of all significant spillages.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

No dangerous reaction known under conditions of normal use.

Strong oxidising agents

No hazardous decomposition products are known.