NOVALKYD S2009-75X

Remove to open air. If breathing is irregular, seek medical advice.

Wash immediately with plenty of water. Remove contaminated clothing. If irritation persists, seek medical attention. Wash contaminated clothing before using them again.

Irrigate copiously with clean, fresh water for at least 15 minutes. Seek medical advice.

Obtain immediate medical attention. Induce vomiting only if indicated by the doctor. Never give anything by mouth to an unconscious person.

Carbon dioxide, foam or chemical powders.

Do not use jets of water.

Excess pressure may form in containers exposed to fire at a risk of explosion.

Water is not effective for putting out fires but can be used to cool containers exposed to flames to prevent explosions.

Do not handle damaged containers or leaked product before donning appropriate protective gear. Block the leakage if there is no hazard.

The product must not penetrate the sewers, surface water, ground water and neighbouring areas.

suck into a suitable container, soak up with absorbent inert material, collect the majority of the remaining material, use spark proof mechanical tools, use jets of water to eliminate product residues

Materials: absorbent inert material (sand, vermiculite, diatomeous earth, Kieselguhr, etc), plastic containers

Do not smoke while handling and use.

Store in a well ventilated place, keep far away from sources of heat, bright flames and sparks and other sources of ignition.

Do not smoke while handling and use.

Do not smoke while handling and use.

As the use of adequate technical equipment must always take priority over personal protection equipment, make sure that the workplace is well aired through effective local aspiration.

Protect hands with category III (ref. Directive 89/686/EEC and standard EN 374) work gloves, such as those in PVA, butyl, fluoroelastomer or equivalent. The following should be considered when choosing work glove material: degradation, breakage times and permeation. Work glove resistance to preparations should be checked before use, as it can be unpredictable. Gloves` limit depends on the duration of exposure.

Wear protective airtight goggles (ref. standard EN 166).

If the threshold value (if available) for one or more of the substances present in the preparation for daily exposure in the workplace or to a fraction established by the company`s prevention and protection service is exceeded, wear a mask with an A or universal filter, the class (1, 2 or 3) of which must be chosen according to the limit concentration of use (ref. standard EN 141). The use of respiratory tract protection equipment, such as masks like that indicated above, is necessary to reduce worker exposure in the absence of technical measures. The protection provided by masks is in any case limited. If the substance in question is odourless or its olfactory threshold is higher than the relative exposure limit and in the event of an emergency, or when exposure levels are unknown or the concentration of oxygen in the workplace is less than 17% volume, wear self-contained, open-circuit compressed air breathing apparatus (ref. standard EN 137) or fresh air hose breathing apparatus for use with full face mask, half mask or mouthpiece (ref. standard EN 138).

Wear category II professional long-sleeved overalls and safety footwear (ref. Directive 89/686/CEE and standard EN 344).

The product is stable in normal conditions of use and storage.

There are no particular risks of reaction with other substances in normal conditions of use.

The vapours may also form explosive mixtures with the air. XYLENE (MIXTURE OF ISOMERS): may develop violent reactions in the presence of strong oxidising agents such as sulphuric and nitric acids and perchlorates. May form explosive mixtures with the air.

Avoid overheating, electrostatic discharge and all sources of ignition.

strong oxidising agents such as sulphuric and nitric acids and perchlorates