Barium chloride dihydrate for analysis EMSURE® ACS, ISO, Reag. Ph Eur

After inhalation: fresh air. If breathing stops: mouth-to-mouth breathing or artificial respiration. Oxygen if necessary. Immediately call in physician.

In case of skin contact: Take off immediately all contaminated clothing. Rinse skin with water/ shower.

After eye contact: rinse out with plenty of water. Call in ophthalmologist. Remove contact lenses.

If swallowed: give water to drink (two glasses at most). Seek medical advice immediately. In exceptional cases only, if medical care is not available within one hour, induce vomiting (only in persons who are wide awake and fully conscious), administer activated charcoal (20 - 40 g in a 10% slurry) and consult a doctor as quickly as possible.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

For this substance/mixture no limitations of extinguishing agents are given.

Hydrogen chloride gas, Barium oxide. Not combustible. Fire may cause evolution of: Hydrogen chloride gas. Ambient fire may liberate hazardous vapours.

Suppress (knock down) gases/vapors/mists with a water spray jet.

Avoid inhalation of dusts. Avoid substance contact. Ensure adequate ventilation. Evacuate the danger area, observe emergency procedures, consult an expert.

Do not let product enter drains.

Take up carefully. Clean up affected area.

Do not inhale substance/mixture. Preventive skin protection recommended.

Tightly closed. Dry. Keep in a well-ventilated place. Keep locked up or in an area accessible only to qualified or authorized persons.

Change contaminated clothing. Wash hands after working with substance.

Full contact: Material: Nitrile rubber, Minimum layer thickness: 0,11 mm, Break through time: 480 min, Material tested: KCL 741 Dermatril® L. Splash contact: Material: Nitrile rubber, Minimum layer thickness: 0,11 mm, Break through time: 480 min, Material tested: KCL 741 Dermatril® L. This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses

required when dusts are generated. Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system. Recommended Filter type: Filter type P3. The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

protective clothing

Do not let product enter drains.

The product is chemically stable under standard ambient conditions (room temperature).

No data available

Risk of explosion with: furan-2-percarbonic acid. Violent reactions possible with: halogen-halogen compounds, Strong oxidizing agents, strong reducing agents, acids.

no information available

various metals, (generation of hydrogen)

In the event of fire: see section 5