PLASTIC STEEL PUTTY(A) RESIN

Move affected person to fresh air at once. Get medical attention if any discomfort continues.

Remove affected person from source of contamination. Wash skin thoroughly with soap and water. Get medical attention if irritation persists after washing.

Remove any contact lenses and open eyelids wide apart. Continue to rinse for at least 15 minutes. Get medical attention if irritation persists after washing.

Rinse mouth thoroughly with water. Do not induce vomiting. If vomiting occurs, the head should be kept low so that vomit does not enter the lungs. Get medical attention.

Extinguish with foam, carbon dioxide or dry powder.

Irritating gases or vapours.

Avoid breathing fire gases or vapours. Keep up-wind to avoid fumes.

Avoid the spillage or runoff entering drains, sewers or watercourses.

Absorb spillage with sand or other inert absorbent. Collect and place in suitable waste disposal containers and seal securely. Containers with collected spillage must be properly labelled with correct contents and hazard symbol.

Materials: sand or other inert absorbent

Use only in well-ventilated areas. Handle and open container with care. Avoid contact with skin and eyes. Keep away from heat, sparks and open flame. Do not eat, drink or smoke when using the product. Good personal hygiene procedures should be implemented.

Store in tightly-closed, original container in a dry, cool and well-ventilated place.

Do not eat, drink or smoke when using the product. Good personal hygiene procedures should be implemented.

Keep away from heat, sparks and open flame.

Provide adequate general and local exhaust ventilation.

Wear protective gloves made of the following material: Rubber or plastic. To protect hands from chemicals, gloves should comply with European Standard EN374. The selected gloves should have a breakthrough time of at least 8 hours.

Eyewear complying with an approved standard should be worn if a risk assessment indicates eye contact is possible. The following protection should be worn: Chemical splash goggles. Personal protective equipment for eye and face protection should comply with European Standard EN166.

If ventilation is inadequate, suitable respiratory protection must be worn. Respirator selection must be based on exposure levels, the hazards of the product and the safe working limits of the selected respirator. Check that the respirator fits tightly and the filter is changed regularly. Wear a respirator fitted with the following cartridge: Gas filter, type A2. Half mask and quarter mask respirators with replaceable filter cartridges should comply with European Standard EN140.

Avoid contact with skin. Wear chemical protective suit.

Stable at normal ambient temperatures and when used as recommended.

Strong oxidising agents. Acids. Amines.

Not available.

Avoid heat, flames and other sources of ignition. Avoid excessive heat for prolonged periods of time. Avoid exposure to high temperatures or direct sunlight.

Strong oxidising agents. Strong acids. Amines.

Oxides of carbon. Thermal decomposition or combustion may liberate carbon oxides and other toxic gases or vapours. Vapours/gases/fumes of: Acids - organic. Aldehydes.