NextSDS Logo
Safety Data Sheet EN

BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER
Synonyms
TURCO ALDOX V

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Cleaners for Aeroplanes

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way, Rocky Hill, Connecticut 06067

+1 (860) 571-5100

www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Met. Corr. Cat. 1
Acute Tox. Cat. 3
Acute Tox. Cat. 3
Skin Corr. Cat. 1B
Eye Dam. Cat. 1
Carc. Cat. 1A

GHS Pictograms

GHS05 - Corrosive

GHS05

GHS06 - Acute toxicity

GHS06

GHS08 - Serious health hazard

GHS08

Hazard Statements

H290 MAY BE CORROSIVE TO METALS.
H301 + H311 TOXIC IF SWALLOWED OR IN CONTACT WITH SKIN
H314 CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
H350 MAY CAUSE CANCER.

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P234 Keep only in original packaging.
P264 Wash affected area thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P280 Wear protective gloves, clothing, eye and face protection.
P301 + P330 + P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P303 + P361 + P353 If on skin (or hair): Take off immediately all contaminated clothing.
P304 + P340 + P310 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Immediately call a POISON CENTER or physician.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P308 + P313 IF exposed or concerned: Get medical attention.
P361 + P364 Take off immediately all contaminated clothing and wash it before reuse.
P390 Absorb spillage to prevent material damage.
P405 Store locked up.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.
IF SWALLOWED: Immediately call a POISON CENTER or doctor/ physician. Rinse mouth.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Ferric sulfate 10028-22-5 30 - 60% Yes
Hydrogen fluoride 7664-39-3 1 - 5% Yes
Nitric acid 7697-37-2 0.1 - 1% Yes
Sulfuric acid 7664-93-9 0.1 - 1% Yes

Notes

* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Remove person immediately to fresh air. Seek medical attention if symptoms develop or persist. If breathing is difficult, give oxygen. Trained personnel should administer 2.5% calcium gluconate through a nebulizer for 20 minutes.

Skin contact

Remove contaminated clothing and footwear while rinsing the affected area with large amounts of running water for at least 15 minutes. GET IMMEDIATE MEDICAL ATTENTION. If iced solution of 0.13% aqueous Benzalkonium Chloride (Zephiran) or 2.5% calcium gluconate gel is available, rinsing may be limited to 5 minutes, with the soak solution or gel applied as soon as the rinsing is stopped. If using calcium gluconate gel, it should be continuously re-applied and massaged into the affected area until pain has been relieved for at least 30 minutes. If Benzalkonium Chloride (Zephiran) or calcium gluconate gel is not available, rinsing must continue until medical treatment is provided.

Eye contact

Immediately flush affected eye with large amounts of gently flowing water or 0.9% sterile saline solution for at least 15 minutes. Hold eyelid wide open. Get immediate medical attention. Eye flushing should continue during transportation to a doctor.

Ingestion

Get immediate medical attention. Do not induce vomiting. Attempt immediate administration of a fluoride binding substance: milk, chewable calcium carbonate tablets or 4-8 ounces (120-240 ml) of milk of magnesia or a liquid antacid. Avoid large amounts of liquid as it may induce vomiting. Never give anything by mouth to an unconscious person.

Immediate Medical Attention

Get immediate medical attention for all exposure routes.

Medical Treatment

Treatment of hypocalcemia associated with corrosive fluoride compounds exposure may be corrected by intravenous calcium gluconate or calcium chloride. Treatment of hypomagnesemia may be corrected by intravenous magnesium sulfate.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Water spray (fog), foam, dry chemical or carbon dioxide.

Unsuitable media

Not available.

Specific hazards

May liberate large quantities of dense, foul-smelling smoke which may contain unidentified toxic gasses. May react with metals to form flammable hydrogen gas.

Instructions

Wear full protective clothing. Wear self-contained breathing apparatus.

Firefighter Protection

Wear full protective clothing. Wear self-contained breathing apparatus.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Prevent further leakage or spillage if safe to do so. Contain spill. Ventilate area. Isolate area. Keep unnecessary personnel away.

Environmental

Prevent further leakage or spillage if safe to do so. Contain spill. Do not allow product to enter sewer or waterways.

Cleanup methods

Collect spilled material with an inert absorbent such as sand or vermiculite. Place in properly labeled closed container. Flush area with water to remove trace residue.

Materials: inert absorbent such as sand or vermiculite

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Avoid contact with eyes, skin and clothing. Provide adequate ventilation. Avoid breathing vapors or mists of this product. Wash thoroughly after handling. Do not reuse the empty container.

Storage

Keep the container tightly closed and in a cool, well-ventilated place.

Hygiene

Wash thoroughly after handling.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
Liquid
Physical State Data
liquid
State Under Standard Conditions
---
Appearance
---
Colour
Dark brown
Colour Intensity
---
Form
---
Odor
Pungent
Odor Threshold
Not available.
Ph
0 - 2
Melting Point
< 0 °C (< 32°F)
Boiling Point
> 200 °F (> 93.3 °C)
Flash Point
> 104 °C (> 219.2 °F); Estimated
Freezing Point
---
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
Not applicable
Vapor Pressure
Not determined
Vapor Density
---
Relative Density
1.29
Bulk Density
---
Density
---
Flammability
Not applicable
Upper Explosive Limit
Not applicable
Lower Explosive Limit
Not applicable
Explosive Limits
---
Auto Ignition Temperature
Not applicable
Decomposition Temperature
Not available.
Solubility
Completely soluble
Partition Coefficient
Not available.
Solubility In Water
---
Solubility In Fat
---
Molecular Weight
---
Voc Content
Not applicable
Metal Corrosion
---
Dynamic Viscosity
Not available.
Kinematic Viscosity
Not available.
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable at normal conditions.

Reactivity

This product may react with strong acids, bases and oxidizing agents. This product may react with strong alkalies. This material will react with glass, concrete, certain metals, silica containing materials, rubber, leather, and many organics. Reacts with cyanides and sulfides to cause the release of poisonous gases.

Hazardous reactions

None under normal processing.

Avoid

Keep away from heat, ignition sources and incompatible materials.

Incompatible

Alkalis.

Decomposition

Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low molecular weight hydrocarbons. May liberate hydrogen fluoride. Oxides of sulfur. Decomposes with heat to produce oxides of nitrogen.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
2922
Shipping Name
Corrosive liquids, toxic, n.o.s. (Hydrofluoric acid, Nitric acid)
Transport Class
8 (6.1)
Packing Group
II
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What other names is BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER known by?

BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER is also known as: TURCO ALDOX V

What is the hazard signal word for BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER?

The signal word is danger.

What is the physical form of BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER?

BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER is a liquid with dark brown color. It has pungent odor.

What is the solubility of BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER?

Completely soluble

What is BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER used for?

Cleaners for Aeroplanes

What are the hazard statements for BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER?

This substance has 4 hazard statements:

  • H290: MAY BE CORROSIVE TO METALS.
  • H301 + H311: TOXIC IF SWALLOWED OR IN CONTACT WITH SKIN
  • H314: CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
  • H350: MAY CAUSE CANCER.

What is the melting point of BONDERITE C-IC ALDOX V AERO ACID DEOXIDIZER?

The melting point is < 0 °C (< 32°F) and the boiling point is > 200 °F (> 93.3 °C).