NextSDS Logo
Safety Data Sheet EN

LOCTITE SF 7070 ODC-FREE CLEANING & DESGREASING known as ODC Free Cleanr Degreaser 150gm

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
LOCTITE SF 7070 ODC-FREE CLEANING & DESGREASING known as ODC Free Cleanr Degreaser 150gm
Product Code
194436

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Solvent based cleaner

Uses advised against

None identified

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way, Rocky Hill, Connecticut 06067

+1 (860) 571-5100

www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Flam. Liq. Cat. 3 H226
Skin Irrit. Cat. 2 H315
Skin Sens. Cat. 1 H317
Asp. Tox. Cat. 1 H304

GHS Pictograms

GHS02 - Flammable

GHS02

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

H226 FLAMMABLE LIQUID AND VAPOUR.
H304 MAY BE FATAL IF SWALLOWED AND ENTERS AIRWAYS.
H315 CAUSES SKIN IRRITATION.
H317 MAY CAUSE AN ALLERGIC SKIN REACTION.

Precautionary Statements

P210 Keep away from heat, sparks, open flames, hot surfaces - no smoking.
P233 Keep container tightly closed.
P240 Ground and bond container and receiving equipment.
P241 Use explosion-proof equipment.
P242 Use non-sparking tools.
P243 Take action to prevent static discharges.
P261 Avoid breathing mist/vapours.
P264 Wash affected area thoroughly after handling.
P272 Contaminated work clothing should not be allowed out of the workplace.
P280 Wear protective gloves, clothing, eye and face protection.
P301 + P310 IF SWALLOWED: Immediately call a physician or poison control center.
P303 + P361 + P353 If on skin (or hair): Take off immediately all contaminated clothing.
P331 Do NOT induce vomiting.
P333 + P313 If skin irritation or rash occurs: Get medical attention.
P362 + P364 Take off contaminated clothing and wash it before reuse.
P370 + P378 In case of fire: Use foam, dry chemical or carbon dioxide to extinguish.
P403 + P235 Store in a well-ventilated place. Keep cool.
P405 Store locked up.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Hydrocarbons, C11-C12, isoalkanes, < 2% aromatics 64742-48-9 80 - 100% Yes
Limonene, D- 5989-27-5 10 - 30% Yes

Notes

* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Move to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.

Skin contact

Wash with soap and water. Remove contaminated clothing and footwear. If symptoms develop and persist, get medical attention.

Eye contact

Immediately flush eyes with plenty of water for at least 15 minutes. If eye irritation persists, consult a specialist.

Ingestion

DO NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Get medical attention.

Immediate Medical Attention

Get medical attention.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Foam, dry chemical or carbon dioxide.

Unsuitable media

Not available.

Specific hazards

Vapors may accumulate in low or confined areas, travel considerable distance to source of ignition, and flash back.

Instructions

Fire fighters should wear positive pressure self-contained breathing apparatus (SCBA). Water may be unsuitable as an extinguishing media, but may be helpful in keeping adjacent containers cool. Avoid spreading liquid with water used for cooling purposes.

Firefighter Protection

Fire fighters should wear positive pressure self-contained breathing apparatus (SCBA).

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Evacuate and ventilate spill area.

Large spill

Maintain good ventilation for large spills.

Environmental

Do not allow product to enter sewer or waterways.

Cleanup methods

Spilled material will solidify.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Keep container closed. Use only with adequate ventilation. Avoid contact with eyes, skin and clothing. Avoid breathing vapors or mists of this product. Wash thoroughly after handling. Do not wear contact lenses. Keep out of the reach of children.

Storage

Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use.

Hygiene

Wash thoroughly after handling. Do not wear contact lenses.

Fire prevention

Keep away from heat, sparks and open flame.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Local exhaust ventilation is recommended when general ventilation is not sufficient to control airborne contamination below occupational exposure limits. Provide local ventilation for prolonged use in a confined area.

Hands

Chemical resistant, impermeable gloves.

Eyes

Safety goggles or safety glasses with side shields.

Respiratory

Use only in well-ventilated areas. Use NIOSH approved respirator if there is potential to exceed exposure limit(s). In case of insufficient ventilation, wear suitable respiratory equipment.

Skin/Body

Chemical resistant, impermeable gloves.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
liquid
Physical State Data
liquid
State Under Standard Conditions
---
Appearance
---
Colour
Blue, Light
Colour Intensity
---
Form
---
Odor
Hydrocarbons
Odor Threshold
Not available.
Ph
Not applicable, Product is non-soluble (in water).
Melting Point
Not applicable, Product is a liquid
Boiling Point
173 - 193 °C (343.4 - 379.4 °F)
Flash Point
39 °C (102.2 °F) ASTM D56 Tagliabue Closed Cup
Freezing Point
---
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
Not available.
Vapor Pressure
5 mm hg (20 °C (68°F))
Vapor Density
---
Relative Density
0.7718
Bulk Density
---
Density
---
Flammability
Flammable liquid
Upper Explosive Limit
5 % 7 %
Lower Explosive Limit
0.7 % 0.6 %
Explosive Limits
---
Auto Ignition Temperature
Not available.
Decomposition Temperature
Not available.
Solubility
Insoluble Water; Miscible Acetone
Partition Coefficient
Not available.
Solubility In Water
---
Solubility In Fat
---
Molecular Weight
---
Voc Content
100 %; 780 g/l
Metal Corrosion
---
Dynamic Viscosity
Not available.
Kinematic Viscosity
1.23 mm2/s
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions of storage and use.

Reactivity

Not available.

Hazardous reactions

Will not occur.

Avoid

Heat, flames, sparks and other sources of ignition. Fire or intense heat may cause violent rupture of packages.

Incompatible

Strong oxidizing agents. Acids and bases.

Decomposition

Oxides of carbon. Irritating vapors.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
1268
Shipping Name
Petroleum distillates, n.o.s. (Stoddard Solvent)
Transport Class
3
Packing Group
III
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for LOCTITE SF 7070 ODC-FREE CLEANING & DESGREASING known as ODC Free Cleanr Degreaser 150gm?

The signal word is danger.

What is the physical form of LOCTITE SF 7070 ODC-FREE CLEANING & DESGREASING known as ODC Free Cleanr Degreaser 150gm?

LOCTITE SF 7070 ODC-FREE CLEANING & DESGREASING known as ODC Free Cleanr Degreaser 150gm is a liquid with blue, light color. It has hydrocarbons odor.

What is the solubility of LOCTITE SF 7070 ODC-FREE CLEANING & DESGREASING known as ODC Free Cleanr Degreaser 150gm?

Insoluble Water; Miscible Acetone

What is LOCTITE SF 7070 ODC-FREE CLEANING & DESGREASING known as ODC Free Cleanr Degreaser 150gm used for?

Solvent based cleaner

What are the hazard statements for LOCTITE SF 7070 ODC-FREE CLEANING & DESGREASING known as ODC Free Cleanr Degreaser 150gm?

This substance has 4 hazard statements:

  • H226: FLAMMABLE LIQUID AND VAPOUR.
  • H304: MAY BE FATAL IF SWALLOWED AND ENTERS AIRWAYS.
  • H315: CAUSES SKIN IRRITATION.
  • H317: MAY CAUSE AN ALLERGIC SKIN REACTION.

What is the melting point of LOCTITE SF 7070 ODC-FREE CLEANING & DESGREASING known as ODC Free Cleanr Degreaser 150gm?

The melting point is Not applicable, Product is a liquid and the boiling point is 173 - 193 °C (343.4 - 379.4 °F).