NextSDS Logo
Safety Data Sheet EN

LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE
Synonyms
N-5000 High Purity Anti-Seize

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Lubricant

Uses advised against

None identified

Manufacturers & Suppliers

Henkel logo

Henkel

manufacturer

+1 (860) 571-5100

www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Skin Irrit. Cat. 2 H315
Eye Irrit. Cat. 2A H319
Skin Sens. Cat. 1 H317
Carc. Cat. 2 H351
STOT RE Cat. 1 H372

GHS Pictograms

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

H315 CAUSES SKIN IRRITATION.
H317 MAY CAUSE AN ALLERGIC SKIN REACTION.
H319 CAUSES SERIOUS EYE IRRITATION.
H351 SUSPECTED OF CAUSING CANCER.
H372 CAUSES DAMAGE TO ORGANS THROUGH PROLONGED OR REPEATED EXPOSURE.

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P260 Do not breathe vapors, mist, or spray.
P264 Wash affected area thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P272 Contaminated work clothing should not be allowed out of the workplace.
P280 Wear protective gloves, clothing, eye and face protection.
P302 + P352 IF ON SKIN: Wash with plenty of water.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P308 + P313 IF exposed or concerned: Get medical attention.
P333 + P313 If skin irritation or rash occurs: Get medical attention.
P337 + P313 If eye irritation persists: Get medical attention.
P362 + P364 Take off contaminated clothing and wash it before reuse.
P405 Store locked up.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
White mineral oil~ --- 30 - 60% Yes
Graphite 7782-42-5 10 - 30% Yes
Nickel 7440-02-0 10 - 30% Yes
Kaolin 1332-58-7 1 - 5% Yes

Concentration range is provided to assist users in providing appropriate protections.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Move to fresh air. If symptoms develop and persist, get medical attention.

Skin contact

Remove contaminated clothing and footwear. Immediately flush skin with plenty of water (using soap, if available). If symptoms develop and persist, get medical attention. Wash clothing before reuse.

Eye contact

Immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention.

Ingestion

Get medical attention. Do not induce vomiting.

Symptoms: Aspiration may cause pulmonary edema and pneumonitis.

Immediate Medical Attention

Aspiration may cause pulmonary edema or aspiration pneumonia.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Foam, extinguishing powder, carbon dioxide.

Unsuitable media

Not available.

Instructions

In case of fire, keep containers cool with water spray.

Firefighter Protection

Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Environmental

Do not allow product to enter sewer or waterways.

Cleanup methods

Scrape up as much material as possible.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Use only with adequate ventilation. Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Keep container closed.

Storage

Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use.

Hygiene

Wash thoroughly after handling.

Fire prevention

Keep in a cool, well ventilated area away from heat, sparks and open flame.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
Paste
Physical State Data
liquid
State Under Standard Conditions
---
Appearance
---
Colour
Gray / Grey
Colour Intensity
---
Form
---
Odor
Petroleum
Odor Threshold
Not available.
Ph
Not available.
Melting Point
Not applicable, Product is a liquid
Boiling Point
Not available.
Flash Point
218 °C (424.4 °F)
Freezing Point
---
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
Slower than butyl acetate.
Vapor Pressure
< 5 mm hg (27 °C (80.6 °F))
Vapor Density
---
Relative Density
---
Bulk Density
---
Density
1.2 ()GRP 1
Flammability
Not applicable
Upper Explosive Limit
Not available.
Lower Explosive Limit
Not available.
Explosive Limits
---
Auto Ignition Temperature
Not available.
Decomposition Temperature
Not available.
Solubility
Negligible Water
Partition Coefficient
Not available.
Solubility In Water
---
Solubility In Fat
---
Molecular Weight
---
Voc Content
Essentially Zero (Exempt Compounds)
Metal Corrosion
---
Dynamic Viscosity
Not available.
Kinematic Viscosity
Not available.
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions of storage and use.

Reactivity

Not available.

Hazardous reactions

Will not occur.

Avoid

Keep away from heat, ignition sources and incompatible materials.

Incompatible

Strong oxidizing agents.

Decomposition

Oxides of carbon. Oxides of sulfur. Oxides of nickel. Oxides of aluminum. Metal oxide fumes.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
3082
Shipping Name
RQ, Environmentally hazardous substance, liquid, n.o.s.
Transport Class
9
Packing Group
III
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What other names is LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE known by?

LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE is also known as: N-5000 High Purity Anti-Seize

What is the hazard signal word for LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE?

The signal word is danger.

What is the physical form of LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE?

LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE is a paste with gray / grey color. It has petroleum odor.

What is the solubility of LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE?

Negligible Water

What is LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE used for?

Lubricant

What are the hazard statements for LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE?

This substance has 5 hazard statements:

  • H315: CAUSES SKIN IRRITATION.
  • H317: MAY CAUSE AN ALLERGIC SKIN REACTION.
  • H319: CAUSES SERIOUS EYE IRRITATION.
  • H351: SUSPECTED OF CAUSING CANCER.
  • H372: CAUSES DAMAGE TO ORGANS THROUGH PROLONGED OR REPEATED EXPOSURE.

What is the melting point of LOCTITE LB N-5000 HIGH PERFORMANCE ANTI-SEIZE?

The melting point is Not applicable, Product is a liquid and the boiling point is Not available..