LOCTITE STYCAST HD 3561 known as HYSOL HD3561 QT

Move to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.

Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and footwear. If symptoms develop and persist, get medical attention. Wash clothing before reuse.

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention.

Do not induce vomiting. Never give anything by mouth to an unconscious person. Get medical attention.

Foam, dry chemical or carbon dioxide.

Not available.

Closed containers may rupture (due to build up of pressure) when exposed to extreme heat.

In case of fire, keep containers cool with water spray.

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Do not allow product to enter sewer or waterways.

Ensure adequate ventilation. Wear appropriate personal protective equipment. Refer to Section 8 "Exposure Controls / Personal Protection" prior to clean up. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Scrape up spilled material and place in a closed container for disposal. Ensure adequate ventilation. Isolate area. Keep unnecessary personnel away. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Store in a partly filled, closed container until disposal. Refer to Section 8 "Exposure Controls / Personal Protection" prior to clean up.

Materials: sand, silica gel, acid binder, universal binder, sawdust

Use only with adequate ventilation. Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Do not taste or swallow. Refer to Section 8.

Keep container tightly closed and in a cool, well-ventilated place away from incompatible materials. Keep away from heat, spark and flame. Store in original container until ready to use. Store away from incompatible materials identified in section 10. Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use. Do not store in reactive metal containers.

Wash thoroughly after handling.

Keep away from heat, spark and flame.

Use local ventilation if general ventilation is insufficient to maintain vapor concentration below established exposure limits. Provide adequate local exhaust ventilation to maintain worker exposure below exposure limits.

Neoprene, Butyl-rubber, or nitrile-rubber gloves.

Safety goggles or safety glasses with side shields. Full face protection should be used if the potential for splashing or spraying of product exists. Safety showers and eye wash stations should be available.

Use a NIOSH approved air-purifying respirator if the potential to exceed established exposure limits exists.

Use chemical resistant, impermeable clothing including gloves and either an apron or body suit to prevent skin contact.

Stable under normal conditions of storage and use.

Not available.

None under normal processing.

Keep away from open flames, hot surfaces and sources of ignition. Store away from incompatible materials.

Acids. Oxidizing agents. Peroxides. Sodium hypochlorite. This product slowly corrodes copper, aluminum, zinc and galvanized surfaces.

Oxides of carbon. Oxides of nitrogen. Ammonia. Irritating vapors. Nitrogen oxide can react with water vapor to form corrosive nitric acid.