Ardrox 9PR5 AEROSOL EA (400mL)

If breathed in, move person into fresh air. If breathing is irregular or stopped, administer artificial respiration. If symptoms persist, call a physician.

Symptoms: May cause drowsiness or dizziness.

Wash off immediately with soap and plenty of water while removing all contaminated clothes and shoes. Do NOT use solvents or thinners. If symptoms persist, call a physician.

Symptoms: Causes skin irritation.

In case of eye contact, remove contact lens and rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. If symptoms persist, call a physician.

Rinse mouth. Do NOT induce vomiting. If symptoms persist, call a physician.

Water spray jet, Dry powder, Alcohol-resistant foam, Carbon dioxide (CO2)

High volume water jet

Cool containers exposed to fire with water. Decomposition, pressure build-up and bursting of containers may occur.

Cool containers/tanks with water spray.

Avoid breathing vapours. For non-emergency personnel: Use personal protective equipment. Ensure adequate ventilation, especially in confined areas. Keep away from sources of ignition. For emergency responders: Advice on product handling can be found in sections 7 and 8 of this safety data sheet.

Do not allow uncontrolled discharge of product into the environment.

soak up with non-combustible absorbent material and transfer to a container for disposal

Materials: non-combustible absorbent material (e.g. sand, earth, diatomaceous earth, vermiculite)

Provide good ventilation of working area (local exhaust ventilation if necessary). Do not return residues to the storage containers. Handle with care - avoid bumps, friction and impact. Smoking, eating and drinking are forbidden in application area. Avoid contact with the skin, eyes and clothing. Handle in accordance with good industrial hygiene and safety practice.

Avoid direct sunlight. Close containers carefully once opened and store them upright in order to prevent any leakage. No smoking. No admission for unauthorised personnel. Always keep in containers of same material as the original one. Observe label precautions. Keep in a dry, cool and well-ventilated place.

Remove contaminated clothing immediately and dispose of safely. Wash hands before breaks and at the end of workday. Keep away from food, drink and animal feedingstuffs.

Avoid all sources of ignition: heat, sparks, open flame. Product may charge electrostatically: always use earthing leads when transferring from one container to another and earth containers. It is recommended that operators should wear antistatic clothing and footwear. The relevant fire protection measures should be noted.

Ensure adequate ventilation.

The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it. nitrile rubber (NBR) - 0.4 mm coating thickness butyl rubber (butyl) - 0.7 mm coating thickness Performance level 6, corresponding to a breakthrough time of >480 min according to EN ISO 374-1 The protection glove should be tested for its specific suitability (e.g. mechanical strength, product compatibility, anti-static properties). Gloves should be discarded and replaced if there is any indication of degradation or chemical breakthrough.

Tightly fitting safety goggles (splash goggles) (e.g. EN 166)

When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. Filter type: Combined particulates, organic gas and low boiling vapor type (AX-P)

Chemical resistant protective clothing according to DIN EN 13034 (Type 6)

No decomposition if stored and applied as directed.

No dangerous reaction known under conditions of normal use.

Risk of bursting. Vapors may form explosive mixture with air.

Heat, flames and sparks. Avoid direct sunlight.

Keep away from oxidizing agents, strongly alkaline and strongly acid materials in order to avoid exothermic reactions.

No decomposition if stored and applied as directed.