DIISOPROPYL ETHER FOR ANALYSIS EMSURE® ACS, REAG. PH EUR

After inhalation: fresh air. Call in physician.

Take off immediately all contaminated clothing. Rinse skin with water/ shower.

After eye contact: rinse out with plenty of water. Remove contact lenses.

After swallowing: immediately make victim drink water (two glasses at most). Consult a physician.

Carbon dioxide (CO2) Foam Dry powder

For this substance/mixture no limitations of extinguishing agents are given.

Combustible. Pay attention to flashback. Vapors are heavier than air and may spread along floors. Development of hazardous combustion gases or vapours possible in the event of fire. Forms explosive mixtures with air at ambient temperatures.

Remove container from danger zone and cool with water.

Do not breathe vapors, aerosols. Avoid substance contact. Ensure adequate ventilation. Keep away from heat and sources of ignition. Evacuate the danger area, observe emergency procedures, consult an expert.

Do not let product enter drains. Risk of explosion.

Take up with liquid-absorbent material (e.g. Chemizorb®). Dispose of properly. Clean up affected area.

Materials: liquid-absorbent material (e.g. Chemizorb®)

Work under hood. Do not inhale substance/mixture. Avoid generation of vapours/aerosols.

Protected from light. Keep container tightly closed in a dry and well-ventilated place. Keep away from heat and sources of ignition.

Change contaminated clothing. Preventive skin protection recommended. Wash hands after working with substance.

Keep away from open flames, hot surfaces and sources of ignition.

Full contact: Material: butyl-rubber, Minimum layer thickness: 0,7 mm, Break through time: 480 min, Material tested: Butoject® (KCL 898). Splash contact: Material: Nitrile rubber, Minimum layer thickness: 0,4 mm, Break through time: 240 min, Material tested: Camatril® (KCL 730 / Aldrich Z677442, Size M). This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN374 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses

Recommended Filter type: Filter A (acc. to DIN 3181) for vapours of organic compounds. The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

Flame retardant antistatic protective clothing.

Do not let product enter drains. Risk of explosion.

The product is chemically stable under standard ambient conditions (room temperature). Contains the following stabilizer(s): butyl hydroxytoluene (BHT) (0,001 %)

Formation of peroxides possible. Vapors may form explosive mixture with air.

Exothermic reaction with: Risk of explosion with: Aldehydes, Amines, mineral acids, Oxidizing agents, Zinc

May form explosive peroxides. Warming. Moisture.

various plastics

Peroxides. In the event of fire: see section 5