NOSOPROTECT

If breathing is difficult, remove to fresh air. Restore breathing. Keep warm and quiet. In case of unconsciousness place patient stably in side position for transportation.

Immediately wash with water and soap and rinse thoroughly. Wash contaminated clothing before use. Remove contaminated clothing.

Rinse opened eye for at least 15 minutes under running water. Remove contact lenses and continue rinsing for several minutes. Avoid strong water jet.

Symptoms: risk of cornea damage

Drink plenty of water and provide fresh air. Never give anything by mouth to an unconscious person.

CO2, powder or water spray. Fight larger fires with water spray.

No further relevant information available.

Avoid contact with skin and eyes. Ensure adequate ventilation. Wear protective clothing. Avoid contact with dripping or leaking material. Use personal protective equipment.

Do not allow to penetrate the ground/soil. Do not allow to enter sewers/ surface or ground water.

Absorb with liquid-binding material

Materials: sand, diatomite, acid binders, universal binders, sawdust, silica gel

Open and handle receptacle with care. Avoid contact with skin, eyes and clothing. Avoid inhaling vapors. Wash your hands thoroughly after handling. Wash contaminated clothing before reuse. Do not eat, drink or smoke during the usage of the product.

Store in cool, dry conditions in well sealed receptacles. Store in a cool location. Protect from heat and direct sunlight.

Wash your hands thoroughly after handling. Wash contaminated clothing before reuse. Do not eat, drink or smoke during the usage of the product.

Keep away from heat, sparks, open flames and hot surfaces.

Provide adequate ventilation.

Protective gloves resistant to chemicals (standard EN 374-1). The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves: The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a mixture of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. Penetration time of glove material: The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed. The determined penetration times according to EN 16523-1:2015 are not performed under practical conditions. Therefore a maximum wearing time, which corresponds to 50% of the penetration time, is recommended.

Tightly sealed goggles (EN 166).

In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.

Chemically resistant, protective work clothing (EN 14605) and boots.

Dispose of flushing liquids in accordance with local and national regulations.

Stable at environment temperature.

No further relevant information available.

No dangerous reactions known.

Oxidising agents

Oxidising agents

No dangerous decomposition products known.

Warning: Corrosive substances.

Warning: Corrosive substances.

Warning: Corrosive substances.