Loxeal 58-11

Move the exposed person to fresh air. Get medical attention if symptoms are severe or persist.

Wash skin thoroughly with soap and water. Remove contaminated clothing. If symptoms develop, obtain medical attention

Symptoms: Prolonged contact may cause redness, irritation and dry skin.

Remove any contact lenses and open eyelids wide apart. Rinse immediately with plenty of water. Continue to rinse for at least 15 minutes. Get medical attention if any discomfort continues.

Symptoms: May cause temporary eye irritation.

Rinse mouth thoroughly with water. Give a few small glasses of water or milk to drink. Never give anything by mouth to an unconscious person. Get medical attention if any discomfort continues.

Foam, carbon dioxide or dry powder.

Do not use water jet as an extinguisher, as this will spread the fire.

Burning produces irritating, toxic and obnoxious fumes.

Avoid discharge into drains or watercourses or onto the ground.

Absorb spillage with sand or other inert absorbent. Transfer to suitable, labelled containers for disposal.

Materials: sand or other inert absorbent

Avoid contact with skin and eyes. Do not eat, drink or smoke when using this product.

Store in tightly-closed, original container in a dry, cool and well-ventilated place. Never return unused material to storage receptacle.

Do not eat, drink or smoke when using this product.

Normal (mechanical) room ventilation should be adequate for small volumes. For higher volume activities, or if needed for worker comfort, local mechanical exhaust should be provided.

It is recommended that chemical-resistant, impervious gloves are worn. Gloves should conform to EN 374. For exposure up to 4 hours, wear gloves made of the following material: Nitrile rubber. Thickness: ≥ 0.4 mm The selected gloves should have a breakthrough time of at least 0.5 hours. For exposure up to 8 hours, wear gloves made of the following material: Nitrile rubber. Thickness: ≥ 0.4 mm The selected gloves should have a breakthrough time of at least 8 hours. The breakthrough time for any glove material may be different for different glove manufacturers. The most suitable glove should be chosen in consultation with the glove supplier/manufacturer, who can provide information about the breakthrough time of the glove material. Considering the data specified by the glove manufacturer, check during use that the gloves are retaining their protective properties and change them as soon as any deterioration is detected.

Use approved safety goggles or face shield. Personal eye protection should conform to EN 166

Respiratory protection not required.

Uniforms, coveralls, or a lab coat should be worn

Stable at normal ambient temperatures and when used as recommended.

The following materials may react with the product: Strong oxidising agents.

No specific material or group of materials is likely to react with the product to produce a hazardous situation.

Avoid heat, flames and other sources of ignition.

Strong acids. Strong alkalis. Strong oxidising agents. Strong reducing agents.

Thermal decomposition could produce carbon monoxide, carbon dioxide, and unidentified organic compounds.