PACKING ZWART

IF INHALED: Remove to fresh air and keep at rest in a position comfortable for breathing.

In the case of skin irritation or allergic reactions see a doctor. Wash skin with soap and water.

Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Consult an ophthalmologist.

Do NOT induce vomiting. If swallowed, call a physician or poison control centre immediately.

Water spray, carbon dioxide (CO2), dry chemical, alcohol-resistant foam.

Full water jet.

Thermal decomposition can lead to release of irritating gases and vapours. Containers may explode when heated.

Do not get in eyes, on skin, or on clothing. Use personal protective equipment as required.

Prevent product from entering drains. Do not allow to enter into soil/subsoil. See Section 12 for additional Ecological Information.

Pick up and transfer to properly labelled containers.

Avoid breathing dust/fume/gas/mist/vapours/spray. Use personal protective equipment. Ensure adequate ventilation. Do not puncture or incinerate cans. Contents under pressure.

Protect from moisture. Keep away from food, drink and animal feeding stuffs. Keep away from heat, sparks, flame and other sources of ignition (i.e., pilot lights, electric motors and static electricity). Keep/store only in original container. Store in a dry place. Store in a closed container. Store in accordance with the particular national regulations.

Do not eat, drink or smoke when using this product. Wash hands before breaks and after work. Take off all contaminated clothing and wash it before reuse.

Keep away from heat, sparks, flame and other sources of ignition (i.e., pilot lights, electric motors and static electricity).

Ensure adequate ventilation, especially in confined areas.

Wear suitable gloves. Recommended use: Neoprene™. Nitrile rubber. Butyl rubber. Glove thickness > 0.7mm. The breakthrough time for the mentioned glove material is in general greater than 480 min. Ensure that the breakthrough time of the glove material is not exceeded. Refer to glove supplier for information on breakthrough time for specific gloves. Gloves must conform to standard EN 374.

Wear safety glasses with side shields (or goggles). Eye protection must conform to standard EN 166.

In case of inadequate ventilation wear respiratory protection. Wear a respirator conforming to EN 140 with Type A/P2 filter or better. Ensure adequate ventilation, especially in confined areas. Recommended filter type: Organic gases and vapours filter conforming to EN 14387. White. Brown.

None under normal use conditions.

Do not allow uncontrolled discharge of product into the environment.

Stable under normal conditions.

Product cures with moisture.

Heating causes rise in pressure with risk of bursting.

Protect from moisture. Exposure to air or moisture over prolonged periods. Do not freeze. Keep away from open flames, hot surfaces and sources of ignition. Extremes of temperature and direct sunlight.

Strong oxidizing agents. Incompatible with oxidizing agents.

None under normal use conditions.