SPECTRASYN 100

Remove from further exposure. Use adequate respiratory protection. If breathing has stopped, assist ventilation with a mechanical device or use mouth-to-mouth resuscitation.

Symptoms: respiratory irritation, dizziness, nausea, or unconsciousness

Wash contact areas with soap and water. If product is injected into or under the skin, or into any part of the body, regardless of the appearance of the wound or its size, the individual should be evaluated immediately by a physician as a surgical emergency.

Symptoms: initial symptoms from high pressure injection may be minimal or absent

Flush thoroughly with water.

Symptoms: irritation

First aid is normally not required. Seek medical attention if discomfort occurs.

Symptoms: discomfort

Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish flames.

Straight streams of water

Evacuate area. Prevent run-off from fire control or dilution from entering streams, sewers or drinking water supply. Use water spray to cool fire exposed surfaces and to protect personnel.

Dyke far ahead of liquid spill for later recovery and disposal.

Prevent entry into waterways, sewers, basements or confined areas.

Prevent small spills and leakage to avoid slip hazard. Material can accumulate static charges which may cause an electrical spark (ignition source). When the material is handled in bulk, an electrical spark could ignite any flammable vapors from liquids or residues that may be present (e.g., during switch-loading operations). Use proper bonding and/or earthing procedures.

Do not store in open or unlabelled containers.

Material can accumulate static charges which may cause an electrical spark (ignition source). Use proper bonding and/or earthing procedures.

No special requirements under ordinary conditions of use and with adequate ventilation.

No protection is ordinarily required under normal conditions of use.

If contact is likely, safety glasses with side shields are recommended.

If engineering controls do not maintain airborne contaminant concentrations at a level which is adequate to protect worker health, an approved respirator may be appropriate. Respirator selection, use, and maintenance must be in accordance with regulatory requirements, if applicable. Types of respirators to be considered for this material include: No protection is ordinarily required under normal conditions of use and with adequate ventilation. For high airborne concentrations, use an approved supplied-air respirator, operated in positive pressure mode. Supplied air respirators with an escape bottle may be appropriate when oxygen levels are inadequate, gas/vapour warning properties are poor, or if air purifying filter capacity/rating may be exceeded.

No skin protection is ordinarily required under normal conditions of use. In accordance with good industrial hygiene practices, precautions should be taken to avoid skin contact.

Comply with applicable environmental regulations limiting discharge to air, water and soil. Protect the environment by applying appropriate control measures to prevent or limit emissions.

Material is stable under normal conditions.

Will not occur.

Excessive heat. High energy sources of ignition.

Strong oxidisers

Material does not decompose at ambient temperatures.

burning in an enclosed controlled burner for fuel value or disposal by supervised incineration at very high temperatures

Product is suitable for burning in an enclosed controlled burner for fuel value or disposal by supervised incineration at very high temperatures to prevent formation of undesirable combustion products.