SN 150 D

Remove the victim (move/carry) from the exposure area to fresh air and keep warm and quiet. Place an unconscious person in the recovery position, loosen tight parts of clothes; control and maintain patency of the airways. Give oxygen in the case of breathing disorders; if not breathing, use artificial ventilation. In the case of loss of consciousness, respiratory disorders or persisting symptoms obtain medical aid immediately.

Symptoms: No adverse effects are expected. May be irritating.

Immediately remove contaminated/soaked clothes and shoes. Thoroughly wash contaminated skin with soapy water or mild detergent, and then rinse with water. Consult a doctor if irritation symptoms appear and persist. NOTE: Take off contaminated/soaked clothes and remove it to a safe place, far from heat and ignition sources.

Symptoms: No adverse effects are expected. May cause skin irritation in susceptible persons.

Flush the contaminated eyes with running water, remove contact lenses (if worn) and continue flushing for approx. 15 minutes. When flushing, keep the eyelids wide open and move the eyeball. Consult a doctor if symptoms appear and persist. NOTE: Do not use a stream of water which is too strong, it may damage the cornea.

Symptoms: No adverse effects are expected. Contact with eyes may cause irritation.

Seek medical attention immediately. DO NOT induce vomiting. If vomiting, hold the person in a forward inclined position, facing the ground.

Symptoms: No adverse effects are expected. May cause nose, throat and lung irritation.

carbon dioxide, powder, alcohol-resistant foam, water spray or water fog.

water jet – risk of spreading the fire.

Heating causes rise in pressure with risk of bursting.

Evacuate area. Use water spray or fog for cooling exposed containers. Contain the extinguishing fluids by bunding. Prevent fire-fighting water from entering the environment.

Evacuate unnecessary personnel. Keep upwind. Provide adequate ventilation. Wear recommended personal protective equipment. Do not breathe vapours. Avoid contact with skin, eyes and clothing. Ensure procedures and training for emergency decontamination and disposal are in place.

Small quantities of liquid spill: take up in non-combustible absorbent material and shovel into container for disposal.

Recover large spills by pumping (use an explosion proof or hand pump). Place in a suitable container for disposal in accordance with the waste regulations (see Section 13).

If it is possible and safe, stop or limit product release. Limit spreading of the great leakages by embanking the area.

take up in non-combustible absorbent material and shovel into container for disposal. Recover large spills by pumping (use an explosion proof or hand pump).

Materials: non-combustible absorbent material

Provide adequate ventilation. Use personal protective equipment as required. Concerning personal protective equipment to use, see section 8. Do not breathe vapors. Avoid contact with skin, eyes and clothing. Take any precaution to avoid mixing with incompatible materials, Refer to Section 10 on Incompatible Materials.

Store in tightly sealed and properly labelled containers, in a cool, well-ventilated place with a non-absorbing ground. The product may be stored in storage tanks in accordance with applicable regulations. Store far from heat sources, protect from direct sunlight. Protect against contamination and water accumulation.

Keep good industrial hygiene. Wash hands and other exposed areas with mild soap and water before eating, drinking or smoking and when leaving work. Do not eat, drink or smoke when using this product. Keep away from food, drink and animal feeding stuffs. Remove contaminated clothes. Separate working clothes from town clothes. Launder separately. Wash contaminated clothing before reuse.

Store far from heat sources.

General ventilation and/or local fume hood in order to maintain hazardous agent concentration in air below acceptable limits.

Suitable material: NBR (Nitrile rubber). Thickness > 0.3 mm. Breakthrough time: 8h. The quality of the protective gloves resistant to chemicals must be chosen as a function of the specific working place concentration and quantity of hazardous substances. It is recommended to change gloves regularly and replace them immediately if any signs of wear or damage (tearing, puncture) or changes in appearance (color, flexibility, shape) occur.

Tight safety eyeglasses (goggles) in the case of prolonged exposure or the risk of liquid splashing to the eye. It is recommended to equip the workplace with a water shower to flush eyes. EN 166.

Not required under normal conditions of use. In case of insufficient ventilation, wear suitable respiratory equipment. Half-face mask (EN 140). Full face mask (EN 136). Filter type: A. The filter class must be suitable for the maximum contaminant concentration (gas/vapor/aerosol/particulates) that may arise when handling the product. If the concentration is exceeded, self-contained breathing apparatus must be used. (EN 137).

Not required for normal conditions of use. Wear protective apron or protective suit made of coated, product-resistant fabrics; oil-resistant, anti-slippery shoes.

Consider using precautionary measures in order to protect the area around storage tanks.

The product is stable under normal conditions of use.

See section 10.4 and 10.5.

No dangerous reactions known under normal conditions of use.

See Section 7.

Strong oxidizing agents.

Carbon oxides (CO, CO2).

Recycling is preferred to disposal or incineration. If recycling is not possible, eliminate in accordance with local valid waste disposal regulations.

Avoid release to the environment. Dispose of empty containers and wastes safely.