NextSDS Logo
Safety Data Sheet EN

JLG

Keep this SDS organized and up to date

Add this SDS to your NextSDS library and keep all its safety information in one place.

Add to my SDS library for free
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
JLG
Product Code
3360017
Synonyms
JLG ORANGE

Regulatory Identifiers

CAS Number
N/A

Identified Uses

AEROSOL SPRAY

Manufacturers & Suppliers

C

Custom-Pak Products Inc.

manufacturer

N118 W18981 Bunsen Drive, Germantown, WI 53022

(262) 251-6180

PPG ARCHITECTURAL FINISHES logo

PPG ARCHITECTURAL FINISHES

distributor

ONE PPG PLACE, PITTSBURGH, PA 15272 USA

http://www.ppg.com

Emergency Contacts

CHEMTREC

1-800-424-9300

CHEMTREC

+1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Aerosol Cat. 1
Press. Gas (Liq.)
Acute Tox. Cat. 4
Skin Irrit. Cat. 2
Eye Irrit. Cat. 2A
Acute Tox. Cat. 4
STOT SE Cat. 3
Muta. Cat. 1A
Carc. Cat. 1A

GHS Pictograms

GHS02 - Flammable

GHS02

GHS04 - Compressed gas

GHS04

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

H222 Extremely flammable aerosol.
H280 Contains gas under pressure; may explode if heated.
H312 Harmful in contact with skin.
H315 Causes skin irritation.
H319 Causes serious eye irritation.
H332 Harmful if inhaled.
H336 May cause drowsiness or dizziness.
H340 May cause genetic defects.
H350 May cause cancer.

Precautionary Statements

P102 Keep out of reach of children.
P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P210 Keep away from heat/sparks/open flames/other ignition sources. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Pressurized container: Do not pierce or burn, even after use.
P261 Avoid breathing vapor/spray.
P264 Wash hands thoroughly after handling.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear eye protection.
P302 + P350 IF ON SKIN: Wash with plenty of soap and water.
P302 + P352 IF ON SKIN: Wash with plenty of soap and water.
P304 + P340 IF INHALED: Remove victim to fresh air and keep comfortable for breathing.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do
P312 Call a POISON CENTER/doctor if you feel unwell.
P337 + P313 If eye irritation persists: Get medical advice/attention.
P403 + P233 Store in a well-ventilated place. Keep container tightly closed when not in use.
P410 + P403 Protect from sunlight. Store in a well-ventilated place.
P410 + P412 Protect from sunlight. Do not expose to temperatures exceeding 50 degrees C/122 degrees F.
P501 Dispose of contents/container in accordance with local/regional/national regulations.

Still copying SDS data manually?Free

You don't have to. NextSDS reads this SDS and adds the information to your library automatically.

Let NextSDS do it for me
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
ACETONE 67-64-1 35 - 40% No
PROPANE 74-98-6 15 - 21% No
N-BUTYL ACETATE 123-86-4 8 - 10% No
XYLENE 1330-20-7 8 - 10% No
N-BUTANE 106-97-8 5 - 8% No
*ETHYLBENZENE 100-41-4 1 - 3% No
*TITANIUM DIOXIDE 13463-67-7 1 - 3% No
ETHYL ESTER 763-69-9 0.1 - 1% No
ALIPHATIC PETROLEUM NAPHTHA 64742-48-9 0.1 - 1% No
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Move person to fresh air and keep in comfortable position for breathing.

Skin contact

Wash with plenty of soap and water. Remove contaminated clothing and wash before reuse.

Eye contact

Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.

Ingestion

Immediately call a poison center/doctor.

Immediate Medical Attention

If breathing difficulty persists: Get medical advice/attention. If skin irritation persists: Get medical advice/attention. If eye irritation persists: Get medical advice/attention. Immediately call a poison center/doctor.

Medical Treatment

Treat symptomatically.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

CO2 (Carbon Dioxide), dry chemical, or water fog.

Unsuitable media

Water spray may be unsuitable. However if water is used fog nozzles are preferable. Water may be used to cool closed containers to prevent pressure build-up and explosion when exposed to extreme heat.

Specific hazards

Closed containers exposed to heat from fire may build pressure and explode.

Firefighter Protection

Full protective equipment including self-contained breathing apparatus should be used.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Environmental

Prevent contamination of soil/ground, waterways, drains, and sewers.

Cleanup methods

Use spark-proof tools to sweep or scrape up, containerize, and dispose of properly.

—

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Vapors may ignite explosively. Prevent buildup of vapors. Keep from sparks, heat, flame or other heat sources. Do not smoke. Turn off pilot lights, heaters, electric motors and other sources of ignition during use and until all vapors are gone. Do not puncture or incinerate/burn container. Keep container tightly closed while not in use.

Storage

Store in dry, well-ventilated area and in accordance with federal, state, and local regulations. Do not expose to heat or store at temperatures above 50 degrees C / 122 degrees F. If storing in cold temperatures, allow product to warm to room temperature before use. Keep container tightly closed and away from heat and sunlight when not in use.

Fire prevention

Keep from sparks, heat, flame or other heat sources. Do not smoke. Turn off pilot lights, heaters, electric motors and other sources of ignition during use and until all vapors are gone.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
Aerosol - Pressurized Liquid
Physical State Data
aerosol
State Under Standard Conditions
---
Appearance
---
Colour
See product identification
Colour Intensity
---
Form
---
Odor
Solvent Odor
Odor Threshold
No data available
Ph
No data available
Melting Point
---
Boiling Point
Not Applicable (pressurized mixture)
Flash Point
less than -18 degrees C (less than -0.4 degrees F), c.c.
Freezing Point
Not Established (mixture)
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
Faster than ether
Vapor Pressure
Not Established (pressurized mixture)
Vapor Density
---
Relative Density
0.770
Bulk Density
---
Density
---
Flammability
---
Upper Explosive Limit
Not Established (mixture)
Lower Explosive Limit
Not Established (mixture)
Explosive Limits
---
Auto Ignition Temperature
---
Decomposition Temperature
---
Solubility
---
Partition Coefficient
---
Solubility In Water
Negligible
Solubility In Fat
---
Molecular Weight
---
Voc Content
45.24
Metal Corrosion
---
Dynamic Viscosity
---
Kinematic Viscosity
---
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions.

Hazardous reactions

Will not occur.

Avoid

Keep away from heat, sparks, and flames.

Incompatible

Strong oxidizing agents.

Decomposition

by fire - Carbon Dioxide and Carbon Monoxide

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

12.1 Toxicity

No data available.

12.2 Persistence and degradability

No data available.

12.3 Bioaccumulative potential

No data available.

12.4 Mobility in soil

No data available.

12.5 Results of PBT and vPvB assessment

No data available.

12.6 Endocrine disrupting properties

No data available.

12.7 Other adverse effects

No data available.
13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

Disposal

Dispose of container and its contents in accordance with federal, state, and local regulations.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
UN1950
Shipping Name
AEROSOLS
Transport Class
2.1
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

All components of this product are listed on or exempt from the following inventories: TSCA (United States), CEPA/DSL (Canada), AICS (Australia), IECSC (China)

Chemical Safety Assessment Not performed
?

Frequently Asked Questions

Common questions about safety, handling, and properties

What other names is JLG known by?

JLG is also known as: JLG ORANGE

What is the hazard signal word for JLG?

The signal word is danger.

What is the physical form of JLG?

JLG is a aerosol - pressurized liquid with see product identification color. It has solvent odor odor.

What is JLG used for?

AEROSOL SPRAY

What are the hazard statements for JLG?

This substance has 9 hazard statements:

  • H222: Extremely flammable aerosol.
  • H280: Contains gas under pressure; may explode if heated.
  • H312: Harmful in contact with skin.
  • H315: Causes skin irritation.
  • H319: Causes serious eye irritation.
  • H332: Harmful if inhaled.
  • H336: May cause drowsiness or dizziness.
  • H340: May cause genetic defects.
  • H350: May cause cancer.