WaferBOND® Remover

Remove victim to fresh air. Give artificial respiration if needed. If breathing is difficult, oxygen should be administered by qualified personnel.

Symptoms: Vapors may cause dizziness, drowsiness and other central nervous systems effects.

Remove contaminated clothing. Wash contact area thoroughly with soap and water. Launder clothing before re-use.

Symptoms: Causes skin irritation.

Rinse thoroughly with water for at least 15 minutes, holding the eye lids open to be sure the material is washed out.

Aspiration hazard: do not induce vomiting. Keep the victim calm and warm.

Symptoms: May cause aspiration during swallowing or vomiting.

Use water fog, foam, carbon dioxide or dry chemical.

Vapors are heavier than air and may travel along surfaces to remote ignition sources and flash back. Vapors may form explosive mixtures with air in confined areas.

Cool fire exposed containers with water.

Report spills and releases as required to appropriate authorities.

Cover with an inert absorbent material and collect into an appropriate container for disposal

Materials: inert absorbent material

Avoid breathing vapors, aerosols and mists. Use with adequate ventilation. Avoid contact with the eyes, skin and clothing. Always wear impervious gloves, chemical safety goggles and protective clothing when handling this material. Wash thoroughly after handling. Do not eat, drink or smoke in the work area. Keep product away from heat, sparks, flames and all other sources of ignition. No smoking in storage or use areas. Keep containers closed when not in use.

Store in a cool, dry, well-ventilated location away from incompatible materials. Keep containers closed when not in use.

Wash thoroughly after handling. Do not eat, drink or smoke in the work area.

Keep product away from heat, sparks, flames and all other sources of ignition. No smoking in storage or use areas.

Use with adequate general or local exhaust ventilation to maintain exposure levels below the occupational exposure limits. Use explosion proof electrical equipment and wiring where required.

Impervious gloves are recommended. Suggested materials for protective gloves include: Nitrile Rubber, or Viton.

Chemical safety goggles recommended.

If needed, an approved respirator with organic vapor cartridges may be used. For higher exposures, a supplied air respirator may be required. Respirator selection and use should be based on contaminant type, form and concentration. Follow applicable regulations and good Industrial Hygiene practice.

Impervious clothing as needed to prevent skin contact and contamination of personal clothing.

Stable

Not reactive

Will not occur.

Keep away from heat, sparks, flames and other sources of ignition.

Strong oxidizing agents.

Combustion will produce oxides of carbon.

Dispose in accordance with all local, state and federal regulations.