KAESER-Schraubenkompressor-Kühl-Öl SIGMA FLUID MOL

Remove casualty to fresh air and keep at rest. When in doubt or if symptoms are observed, get medical advice.

Take off immediately all contaminated clothing. Rinse skin with water/shower. In case of skin irritation, consult a physician.

Symptoms: Causes mild skin irritation.

Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. In case of eye irritation consult an ophthalmologist.

Rinse mouth immediately and drink plenty of water. Do NOT induce vomiting. Never give anything by mouth to an unconscious person or a person with cramps. When in doubt or if symptoms are observed, get medical advice.

Symptoms: few or no symptoms expected. If any, nausea and diarrhoea might occur.

Carbon dioxide (CO2), Dry extinguishing powder. In case of major fire and large quantities: Water spray jet, Foam.

High power water jet

Can be released in case of fire: Carbon dioxide (CO2). Carbon monoxide. Nitrogen oxides (NOx). Sulfur oxides.

Co-ordinate fire-fighting measures to the fire surroundings. Use water spray jet to protect personnel and to cool endangered containers.

Avoid contact with skin, eyes and clothes.

Do not allow to enter into surface water or drains. Prevent spread over a wide area (e.g. by containment or oil barriers). Cover drains.

Absorb with liquid-binding material; Clean contaminated objects and areas thoroughly observing environmental regulations.

Materials: liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents)

Do not breathe vapour/aerosol. Avoid contact with skin, eyes and clothes. Wear personal protection equipment (refer to section 8). Special danger of slipping by leaking/spilling product.

Keep container tightly closed and in a well-ventilated place. Keep only in original container. Make sure spills can be contained, e.g. in sump pallets or kerbed areas.

General protection and hygiene measures: See section 8.

Usual measures for fire prevention.

Vapours / aerosols should be extracted by suction directly at point of origin.

In case of prolonged or frequently repeated skin contact: Wear suitable gloves. Standard: AS/NZS 2161 Set: 2008. Suitable material: NBR (Nitrile rubber). Thickness of the glove material 0,35 mm. Breakthrough time > 480 min. Check leak tightness/impermeability prior to use. Breakthrough times and swelling properties of the material must be taken into consideration.

Wear safety glasses; chemical goggles (if splashing is possible).

With correct and proper use, and under normal conditions, breathing protection is not required. Respiratory protection necessary at: Generation/formation of aerosols. Recommended respiratory protection articles: Combination filtering device (AS/NZS 1716:2003). The filter class must be suitable for the maximum contaminant concentration (gas/vapour/aerosol/particulates) that may arise when handling the product. If the concentration is exceeded, self-contained breathing apparatus must be used.

Protective clothing.

Do not allow uncontrolled discharge of product into the environment.

The product is chemically stable under recommended conditions of storage, use and temperature.

No information available.

Reacts with: Oxidizing agents, strong.

UV-radiation/sunlight. Heat.

Oxidizing agents, strong.

No information available.

Dispose of waste according to applicable legislation. Consult the local waste disposal expert about waste disposal.

Dispose of waste according to applicable legislation. Consult the local waste disposal expert about waste disposal.