NextSDS Logo
Safety Data Sheet EN

Super 77 Aerosol Spray Low 25% VOC

Keep this SDS organized and up to date

Add this SDS to your NextSDS library and keep all its safety information in one place.

Add to my SDS library for free
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Super 77 Aerosol Spray Low 25% VOC
Product Code
62-4876-4930-3, 62-4876-4935-2

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Adhesive, Industrial use

Manufacturers & Suppliers

3

3M

manufacturer

3M Center, St. Paul, MN 55144-1000, USA

1-888-3M HELPS (1-888-364-3577)

Emergency Contacts

Emergency Contact

1-800-364-3577

24 hours

Emergency Contact

(651) 737-6501

24 hours

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Aerosol Cat. 1
Press. Gas (Dis.)
Eye Irrit. Cat. 2A
STOT SE Cat. 1
STOT SE Cat. 3

GHS Pictograms

GHS02 - Flammable

GHS02

GHS04 - Compressed gas

GHS04

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

H222 Extremely flammable aerosol.
H280 Contains gas under pressure; may explode if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
H370 Causes damage to organs: cardiovascular system

Precautionary Statements

P102 Keep out of reach of children.
P210 Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Pressurized container: Do not pierce or burn, even after use.
P260 Do not breathe dust/fume/gas/mist/vapors/spray.
P264 Wash thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear eye/face protection.
P304 + P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P307 + P311 IF exposed: Call a POISON CENTER or doctor/physician.
P321 Specific treatment (see Notes to Physician on this label).
P337 + P313 If eye irritation persists: Get medical advice/attention.
P403 + P233 Store in a well-ventilated place. Keep container tightly closed.
P405 Store locked up.
P410 + P412 Protect from sunlight. Do not expose to temperatures exceeding 50C/122F.
P501 Dispose of contents/container in accordance with applicable local/regional/national/international regulations.

Still copying SDS data manually?Free

You don't have to. NextSDS reads this SDS and adds the information to your library automatically.

Let NextSDS do it for me
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Acetone 67-64-1 35 - 45% No
Non-hazardous components --- 10 - 25% No
1,1-Difluoroethane 75-37-6 10 - 15% No
Cyclohexane 110-82-7 5 - 15% No
Propane 74-98-6 10 - 15% No
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Remove person to fresh air. Get medical attention.

Skin contact

Wash with soap and water. If signs/symptoms develop, get medical attention.

Eye contact

Immediately flush with large amounts of water. Remove contact lenses if easy to do. Continue rinsing. Get medical attention.

Ingestion

Rinse mouth. If you feel unwell, get medical attention.

Medical Treatment

Exposure may increase myocardial irritability. Do not administer sympathomimetic drugs unless absolutely necessary.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Use a fire fighting agent suitable for the surrounding fire.

Specific hazards

Closed containers exposed to heat from fire may build pressure and explode.

Instructions

Water may not effectively extinguish fire; however, it should be used to keep fire-exposed containers and surfaces cool and prevent explosive rupture.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Evacuate area. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools. Ventilate the area with fresh air.

Large spill

For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapors, in accordance with good industrial hygiene practice.

Environmental

Avoid release to the environment.

Cleanup methods

Mix in sufficient absorbent until it appears dry. Collect as much of the spilled material as possible using non-sparking tools. Clean up residue with an appropriate solvent selected by a qualified and authorized person.

—

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Keep out of reach of children. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Do not breathe dust/fume/gas/mist/vapors/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Avoid release to the environment. Avoid contact with oxidizing agents (eg. chlorine, chromic acid etc.)

Storage

Store in a well-ventilated place. Keep container tightly closed. Protect from sunlight. Do not expose to temperatures exceeding 50C/122F. Store away from heat.

Hygiene

Do not eat, drink or smoke when using this product. Wash thoroughly after handling.

Fire prevention

Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapors/spray. If ventilation is not adequate, use respiratory protection equipment.

Hands

Gloves made from the following material(s) are recommended: Fluoroelastomer, Nitrile Rubber, Polyvinyl Alcohol (PVA)

Eyes

Indirect Vented Goggles

Respiratory

An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator type(s) to reduce inhalation exposure: Half facepiece or full facepiece air-purifying respirator suitable for organic vapors. For questions about suitability for a specific application, consult with your respirator manufacturer.

Skin/Body

Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions. Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective clothing.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Language Code
---
Physical State
Aerosol
Physical State Data
aerosol
State Under Standard Conditions
---
Appearance
clear, solvent odor
Colour
clear
Colour Intensity
---
Form
---
Odor
solvent odor
Odor Threshold
No Data Available
Ph
Not Applicable
Melting Point
Not Applicable
Boiling Point
-44 °F [Details:Acetone]
Flash Point
-156 °F [Test Method:Closed Cup]
Freezing Point
---
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
>1 [Ref Std:BUOAC=1]
Vapor Pressure
<=4137 mmHg [@ 68 °F]
Vapor Density
> 1 [Ref Std:AIR=1]
Relative Density
0.80 [Ref Std:WATER=1]
Bulk Density
---
Density
0.80 g/ml
Flammability
Not Applicable
Upper Explosive Limit
12.8 % volume
Lower Explosive Limit
1.3 % volume
Explosive Limits
---
Auto Ignition Temperature
---
Decomposition Temperature
---
Solubility
---
Partition Coefficient
---
Solubility In Water
---
Solubility In Fat
---
Molecular Weight
---
Voc Content
<=25 % [Test Method:calculated per CARB title 2]
Metal Corrosion
---
Dynamic Viscosity
<=100 centipoise [@ 73.4 °F ]
Kinematic Viscosity
---
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable.

Reactivity

This material may be reactive with certain agents under certain conditions - see the remaining headings in this section.

Hazardous reactions

Hazardous polymerization will not occur.

Avoid

Heat, Sparks and/or flames

Incompatible

Not determined

Decomposition

None known.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

12.1 Toxicity

Please contact the address or phone number listed on the first page of the SDS for additional ecotoxicological information on this material and/or its components.

12.2 Persistence and degradability

Please contact the address or phone number listed on the first page of the SDS for additional chemical fate information on this material and/or its components.

12.3 Bioaccumulative potential

No information provided.

12.4 Mobility in soil

No information provided.

12.5 Results of PBT and vPvB assessment

No information provided.

12.6 Endocrine disrupting properties

No information provided.

12.7 Other adverse effects

No information provided.
13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

Disposal

Dispose of contents/container in accordance with the local/regional/national/international regulations.

Waste Codes

D001 Ignitable RCRA
14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

Contact 3M for more information.

Chemical Safety Assessment Not performed

Contact 3M for more information.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for Super 77 Aerosol Spray Low 25% VOC?

The signal word is danger.

What is the physical form of Super 77 Aerosol Spray Low 25% VOC?

Super 77 Aerosol Spray Low 25% VOC is a aerosol appearing as clear, solvent odor with clear color. It has solvent odor odor.

What is Super 77 Aerosol Spray Low 25% VOC used for?

Adhesive, Industrial use

What are the hazard statements for Super 77 Aerosol Spray Low 25% VOC?

This substance has 5 hazard statements:

  • H222: Extremely flammable aerosol.
  • H280: Contains gas under pressure; may explode if heated.
  • H319: Causes serious eye irritation.
  • H336: May cause drowsiness or dizziness.
  • H370: Causes damage to organs: cardiovascular system

What is the melting point of Super 77 Aerosol Spray Low 25% VOC?

The melting point is Not Applicable and the boiling point is -44 °F [Details:Acetone].