RONOL Thread Cutting Oil

Ensure supply of fresh air. In case of persisting adverse effects consult a physician.

When in contact with the skin, clean with soap and water. Consult a doctor if skin irritation persists.

Remove contact lenses. Rinse eye thoroughly under running water keeping eyelids wide open and protecting the unaffected eye (at least 10 to 15 minutes). Get immediate ophthalmic treatment.

Rinse mouth thoroughly with water. Do not induce vomiting. Never give anything by mouth to an unconscious person. Get medical attention if pain still persists.

Symptoms: Gastrointestinal complaints

Carbon dioxide; Extinguishing powder; Water spray jet; Fight big fire with directed water spray or Alcohol-resistant foam

High power water jet

In the event of fire, the following can be released: Carbon dioxide (CO2); Carbon monoxide (CO); Nitrogen oxides (NOx); Sulphur oxides (SxOy)

Cool endangered containers with water spray jet. pay attention to backfire.

Refer to protective measures listed in sections 7 and 8. High risk of slipping due to leakage/spillage of product.

Do not discharge into the drains/surface waters/groundwater. Do not discharge into the subsoil/soil.

Pick up with absorbent material

Materials: sand, kieselguhr, acid binder, universal binder, sawdust

Product inherent handling risks must be minimised taking the appropriate measures for protection and preventive actions. The working process should be designed to rule out the release of hazardous substances or skin contact as far it is possible by the state of the art. Avoid formation of oil dust.

Keep container tightly closed and dry in a cool, well-ventilated place. Containers which are opened must be carefully resealed and kept upright to prevent leakage. Always keep in containers of same material as the original one.

Do not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Wash hands before breaks and after work. Do not inhale vapours. Remove soiled or soaked clothing immediately.

Take precautionary measures against static charges.

Ensure adequate ventilation, local exhaust at the work station if necessary.

In case of intensive contact, wear protective gloves (EN 374). Before use, the protective gloves should be tested in any case for its specific work-station suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the manufacturer's instructions and information relating to the use, storage, care and replacement of protective gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Design operations thus to avoid permanent use of protective gloves. Appropriate Material: nitrile rubber. Breakthrough time: >= 480 min. Appropriate Material: chloroprene

Safety glasses (EN 166)

If workplace exposure limits are exceeded, a respiration protection approved for this particular job must be worn. In case of aerosol and mist formation, take appropriate measures for breathing protection in the event workplace threshold values are not specified. Respiratory filter (gas): ABEK

Chemical-resistant work clothes. Protective shoes.

No data available.

Stable under recommended storage and handling conditions (See section 7).

No data available.

Dangerous reactions are not to be expected when handling product according to its intended use.

Heat, naked flames and other ignition sources.

Oxidizing agents

No data available.

Residuals must be removed from packaging and when emptied completely disposed of in accordance with the regulations for waste removal.

Dispose of according to all applicable regulations upon consultation of the local competent authorities and the disposer in a suitable and authorised disposal facility.