RIDGID High Performance Thread Cutting Oil

Move to fresh air. Call a physician if symptoms develop or persist.

Wash off with soap and water. Get medical attention if irritation develops and persists.

Symptoms: Frequent or prolonged contact may defat and dry the skin, leading to discomfort and dermatitis.

Rinse with water. Get medical attention if irritation develops and persists.

Rinse mouth thoroughly. If swallowed, do NOT induce vomiting. Get medical attention if symptoms occur.

Foam. Dry chemicals. Carbon dioxide (CO2). Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

Do not use water jet as an extinguisher, as this will spread the fire.

See also section 10.

Cool containers exposed to heat with water spray and remove container if no risk is involved.

For non-emergency personnel: Wear appropriate personal protective equipment. For emergency responders: Keep unnecessary personnel away. Use personal protection recommended in Section 8 of the SDS.

Wipe up with absorbent material (e.g., cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers.

Avoid discharge into drains, water courses or onto the ground.

Wipe up with absorbent material (e.g., cloth, fleece). Clean surface thoroughly to remove residual contamination.

Avoid prolonged or repeated contact with skin. Avoid prolonged exposure. Wash hands after handling. Handle in accordance with good industrial hygiene and safety practices.

Store in closed original container in a dry place.

Wash hands after handling. Handle in accordance with good industrial hygiene and safety practices.

Keep away from heat and sources of ignition.

Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Ensure adequate ventilation, especially in confined areas.

After use, please wash hands with soap and water and apply barrier cream if available.

Wear safety glasses with side shields (or goggles).

In case of insufficient ventilation, wear suitable respiratory equipment.

Wear protective clothing and equipment appropriate for the risk of exposure. Be aware of other hazards such as "rotating parts". Contact health and safety professional or manufacturer for specific information.

Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation. Fume scrubbers, filters or engineering modifications to the process equipment may be necessary to reduce emissions to acceptable levels.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

No dangerous reaction known under conditions of normal use.

Avoid temperatures exceeding the flash point. Contact with incompatible materials.

Strong oxidising agents.

Carbon oxides. Sulphur compounds.