High Performance Thread Cutting Oil (Europe)

Move to fresh air. Call a physician if symptoms develop or persist.

Wash off with soap and water. Get medical attention if irritation develops and persists.

Symptoms: Frequent or prolonged contact may defat and dry the skin, leading to discomfort and dermatitis.

Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.

Rinse mouth thoroughly. If swallowed, do NOT induce vomiting. Get medical attention if symptoms occur.

Foam. Dry chemicals. Carbon dioxide (CO2). Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

Do not use water jet as an extinguisher, as this will spread the fire.

See also section 10

In case of fire and/or explosion do not breathe fumes. Cool containers exposed to heat with water spray and remove container, if no risk is involved.

Wear appropriate personal protective equipment. Keep unnecessary personnel away.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers.

Avoid discharge into drains, water courses or onto the ground.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: absorbent material (e.g. cloth, fleece)

Avoid prolonged or repeated contact with skin. Avoid prolonged exposure. Wash hands after handling. Handle in accordance with good industrial hygiene and safety practices.

Keep away from heat and sources of ignition. Store in closed original container in a dry place. Store away from incompatible materials (see Section 10 of the SDS).

Wash hands after handling. Handle in accordance with good industrial hygiene and safety practices.

Keep away from heat and sources of ignition.

Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Ensure adequate ventilation, especially in confined areas.

Use protective gloves made of: Nitrile. Polyvinyl chloride (PVC).

Wear safety glasses with side shields (or goggles).

In case of insufficient ventilation, wear suitable respiratory equipment.

Normal work clothing (long sleeved shirts and long pants) is recommended.

Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation. Fume scrubbers, filters or engineering modifications to the process equipment may be necessary to reduce emissions to acceptable levels.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

No dangerous reaction known under conditions of normal use.

Avoid temperatures exceeding the flash point. Contact with incompatible materials.

Strong oxidizing agents.

Carbon oxides. Sulphur compounds.