CONDACLEAN S

Move to fresh air. Call a physician if symptoms develop or persist.

Remove contaminated clothing. Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/attention. Wash contaminated clothing before reuse.

Symptoms: skin irritation

Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention immediately.

Symptoms: Severe eye irritation.

Rinse mouth. If swallowed, do NOT induce vomiting. Get medical attention if symptoms occur.

Dry chemical, CO2, or water spray. Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

Not relevant.

None known. See also section 10.

In case of fire and/or explosion do not breathe fumes. In the event of fire and/or explosion do not breathe fumes.

Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear appropriate protective equipment and clothing during clean-up. Do not breathe vapour. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all environmental releases. Prevent further leakage or spillage if safe to do so.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: absorbent material (e.g. cloth, fleece)

Do not breathe vapour. Do not get this material in contact with eyes. Avoid contact with eyes, skin, and clothing. Avoid prolonged exposure. Wear appropriate personal protective equipment.

Store in closed original container in a dry place. Keep from freezing.

Observe good industrial hygiene practices. Wash hands after handling. Handle in accordance with good industrial hygiene and safety practices.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Ensure adequate ventilation, especially in confined areas. Provide eyewash station and safety shower.

Use protective gloves made of: Nitrile. Polyvinyl chloride (PVC).

Wear safety glasses with side shields (or goggles) and a face shield.

In case of insufficient ventilation, wear suitable respiratory equipment.

Wear appropriate chemical resistant clothing.

Inform appropriate managerial or supervisory personnel of all environmental releases.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

No dangerous reaction known under conditions of normal use.

Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. Contact with incompatible materials. Avoid frost.

Avoid contact with acids.

Nitrogen compounds. At thermal decomposition temperatures, carbon monoxide and carbon dioxide.

Dispose of in accordance with local regulations.

This material and its container must be disposed of in a safe manner.