ALUMINIUM RESISTANT CASTABLE

Remove to fresh air, drink water to clear throat and blow nose to evacuate dust.

Symptoms: Irritation or soreness in throat and nose. In extreme exposures some congestion may occur.

Rinse affected areas with water and wash gently with soap. Do not use detergent.

Symptoms: Temporary irritation or rash.

Flush eyes with large quantities of water.

Symptoms: Temporary irritation or inflammation.

Drink plenty of water.

Symptoms: May cause temporary irritation and disturbance to the gastro-intestinal system.

Use extinguishing agent suitable for type of surrounding combustible materials. for packaging material only.

Special Procedures: None required.

Do not flush spillage to drain and prevent from entering natural water courses. Material hardens in contact with water. Do not allow to be wind blown.

Use a vacuum cleaner with a high-efficiency filter fitted to the exhaust; otherwise ensure the area is wetted down prior to brushing.

Keep dust level to a minimum and below OEL (Occupational Exposure Limit).

Store dry and cool conditions, away from ferns heat that may cause damage to packing material.

away from ferns heat that may cause damage to packing material

Use engineering control such as dust extraction a point of work to keep dust level to the lowest (See also Section 8 - Specific Control Parameters). In addition use a vacuum cleaner fitted with HEPA filters to collect debris.

Use of gloves is recommended.

Wear goggles or safety glasses with side shields. Do not wear contact lenses.

Use approved and adapted protective equipments against excessive concentrations of nuisance dust, crystalline silica or other possible contaminants which could have been introduced in the material during its use. For airborne dust concentration below the limit value: optional use of approved and adapted respirator (e.g. 3M 5810 or equivalent). When the airborne dust concentration exceeds more than 3 times the limit value, use a mask such as 3M 9920 or Moldex Matrix 2405 or 3M Easy Air 7200 or equivalent. Insure always proper fit when using respiratory protection equipment.

Wear overalls which are loose fitting at the neck and wrists.

damp conditions in storage, rapid loss of the chemical combined water during heat up

Unused material can be disposed of in a solid waste landfill site licensed for the disposal of industrial waste.

Before destruction of the refractory lining, it is advised that the customer evaluates any changes to the product that may occur by the introduction of substances, or operating conditions outside the control of the Vendor.