RIDGID Extreme Performance Thread Cutting Oil (United States)

Move to fresh air. Call a POISON CENTER/doctor if you feel unwell.

Remove contaminated clothing and shoes. Wash contact areas with soap and water. If skin irritation occurs: Get medical advice/attention.

Immediately flush with plenty of water for at least 15 minutes. If easy to do, remove contact lenses. Get medical attention.

Rinse mouth thoroughly. Call a POISON CENTER/doctor if you feel unwell. Do NOT induce vomiting.

Water spray, fog, CO2, dry chemical, or regular foam. Use fire-extinguishing media appropriate for surrounding materials.

Do not use water jet as an extinguisher, as this will spread the fire.

Heat may cause the containers to explode. During fire, gases hazardous to health may be formed.

No data available.

Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Keep unauthorized personnel away.

Absorb spill with vermiculite or other inert material, then place in a container for chemical waste.

Dike far ahead of larger spill for later recovery and disposal.

Do not contaminate water sources or sewer. Prevent further leakage or spillage if safe to do so.

Absorb spill with vermiculite or other inert material, then place in a container for chemical waste.

Materials: vermiculite or other inert material

Avoid contact with eyes. Wash hands thoroughly after handling. Observe good industrial hygiene practices. Wear appropriate personal protective equipment. Do not expose to intense heat as product may expand and pressurize container.

Store in original tightly closed container. Avoid contact with oxidizing agents. Store away from incompatible materials.

Wash hands thoroughly after handling. Observe good industrial hygiene practices.

Do not expose to intense heat as product may expand and pressurize container.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level.

Wear safety glasses with side shields (or goggles).

In case of inadequate ventilation use suitable respirator. Seek advice from supervisor on the company's respiratory protection standards.

Wear protective clothing appropriate for the risk of exposure. Be aware of other hazards such as rotating parts. Contact health and safety professional or manufacturer for specific information.

Material is stable under normal conditions.

Not reactive during normal use.

None under normal conditions.

Avoid heat or contamination.

No data available.

Thermal decomposition or combustion may liberate carbon oxides and other toxic gases or vapors. Contains a component which may release flammable substances, including trimethylpentene, by distillation in systems with solvent recovery. This may lead to accumulation in the solvent circuit.

Dispose of waste at an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.