Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- Neufoam FX
- Product Form
- Mixture
- Product Code
- 016145
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
No information available
Uses advised against
No information available
Manufacturers & Suppliers
FLN Feuerlöschgeräte Neuruppin Vertriebs GmbH
manufacturer
4 Martin-Ebell-Strasse, Neuruppin, Germany 16816
+49.3391.689-0
Emergency Contacts
CHEMTREC
001-800-424-9300
CHEMTREC
001-703-527-3887
Poison Information Centre
+32 (0)70 245 245
Poison Control Center of the Charité - Berlin University of Medicine
030/19240
NVIC
+31 (0)30 274 8888
Norwegian Poison Information Centre
+47 22 59 13 00
Emergency Contact
+32-70 245 245
Emergency Contact
8002 5500
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
GHS04
GHS07
GHS08
Hazard Statements
Precautionary Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
This product does not contain candidate substances of very high concern at a concentration >=0.1% (Regulation (EC) No. 1907/2006 (REACH), Article 59)
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| Ethylene Glycol EC: 203-473-3 | 107-21-1 | 20 - 40% | Yes |
| Calcium chloride dihydrate | 10035-04-8 | 3 - 7% | Yes |
| 2-(2-Butoxyethoxy)ethanol EC: 203-961-6 | 112-34-5 | 3 - 7% | Yes |
Acute Toxicity Estimate If LD50/LC50 data is not available or does not correspond to the classification category, then the appropriate conversion value from CLP Annex I, Table 3.1.2, is used to calculate the acute toxicity estimate (ATEmix) for classifying a mixture based on its components
Notes
Full text of H- and EUH-phrases: see section 16
First Aid Measures
Emergency procedures for chemical exposure incidents
Remove to fresh air.
Wash skin with soap and water. In the case of skin irritation or allergic reactions see a doctor.
Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Keep eye wide open while rinsing. Do not rub affected area. Get medical attention if irritation develops and persists.
If swallowed: Call a POISON CENTER or doctor/physician if you feel unwell
Medical Treatment
Treat symptomatically.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. CAUTION: Use of water spray when fighting fire may be inefficient.
Do not scatter spilled material with high pressure water streams.
No information available.
Firefighter Protection
Firefighters should wear self-contained breathing apparatus and full firefighting turnout gear. Use personal protection equipment.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Avoid contact with skin, eyes or clothing. Use personal protective equipment as required.
See Section 12 for additional Ecological Information.
Take up mechanically, placing in appropriate containers for disposal.
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Handle in accordance with good industrial hygiene and safety practice. Avoid contact with skin, eyes or clothing. Do not eat, drink or smoke when using this product.
Store in a well-ventilated place. Keep cool. Keep container tightly closed. Guard against dust accumulation of material. Use care in handling/storage. Pressurized extinguishers should be properly stored and secured to prevent falling or being knocked over.
Avoid contact with skin, eyes or clothing. Wear suitable gloves and eye/face protection. Do not eat, drink or smoke when using this product.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Ensure adequate ventilation, especially in confined areas.
Wear suitable gloves.
If splashes are likely to occur, wear safety glasses with side-shields.
No protective equipment is needed under normal use conditions. If exposure limits are exceeded or irritation is experienced, ventilation and evacuation may be required.
Wear suitable protective clothing.
No information available.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable under normal conditions.
No information available.
None under normal processing.
Extremes of temperature and direct sunlight.
Strong oxidising agents. Strong acids. Strong bases.
None known based on information supplied.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
Dispose of in accordance with local regulations. Dispose of waste in accordance with environmental legislation.
Dispose of in accordance with local regulations. Dispose of waste in accordance with environmental legislation.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- UN Number
- UN1044
- Shipping Name
- Fire extinguishers
- Transport Class
- 2.2
- Packing Group
- Not regulated
225
Regulatory Information
Chemical regulations, safety assessments, and compliance status
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for Neufoam FX?
The signal word is warning.
What is the physical form of Neufoam FX?
Neufoam FX is a liquid with no information available color. It has characteristic. odor.
What is the solubility of Neufoam FX?
No data available
What is Neufoam FX used for?
No information available
What are the hazard statements for Neufoam FX?
This substance has 4 hazard statements:
- H280: Contains gas under pressure; may explode if heated
- H302: Harmful if swallowed
- H319: Causes serious eye irritation
- H373: May cause damage to organs through prolonged or repeated exposure
What is the melting point of Neufoam FX?
The melting point is No data available and the boiling point is No data available.