Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- SIRAFAN SPEED
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
Disinfectant
Uses advised against
Reserved for industrial and professional use.
Manufacturers & Suppliers
Ecolab Gulf FZE
P.O. Box 17063, Jebel Ali Free Zone Area, Near Container Terminal 3 - North Zone Dubai, UAE
00971 4 8014444
Nalco Egypt Trading
5th Settlement, South 90th St., The Address Building No 67th – 1st floor, New Cairo, Cairo, Egypt 11835
0020 2 25 37 1195
Ecolab Maroc S.A.R.L.
Batiment, Lot. Mounir 1, Parc Industriel, Attawfik, Route 1029, Sidi Maarouf, Casablanca, Morocco
00212 22 58 25 30 - 35
Emergency Contacts
Trans-European
+32-(0)3-575-5555
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
GHS02
GHS07
Hazard Statements
Precautionary Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
First Aid Measures
Emergency procedures for chemical exposure incidents
Remove to fresh air. Treat symptomatically. Get medical attention if symptoms occur.
Wash off immediately with plenty of water for at least 15 minutes. Use a mild soap if available. Get medical attention if irritation develops and persists.
Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/ attention.
Rinse mouth. Get medical attention if symptoms occur.
Immediate Medical Attention
Get medical attention if symptoms occur (inhalation/ingestion), if irritation develops and persists (skin), or if eye irritation persists.
Medical Treatment
Treat symptomatically.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.
High volume water jet
Fire Hazard. Keep away from heat and sources of ignition. Flash back possible over considerable distance. Beware of vapours accumulating to form explosive concentrations. Vapours can accumulate in low areas.
In the event of fire and/or explosion do not breathe fumes.
Firefighter Protection
Use personal protective equipment.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Remove all sources of ignition. Ensure clean-up is conducted by trained personnel only. Refer to protective measures listed in sections 7 and 8.
For large spills, dike spilled material or otherwise contain material to ensure runoff does not reach a waterway.
Do not allow contact with soil, surface or ground water.
Collect with non-combustible absorbent material and place in container for disposal according to local / national regulations. Flush away traces with water.
Materials: non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite)
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Avoid contact with skin and eyes. Do not breathe dust/fume/gas/mist/vapours/spray. Use only with adequate ventilation. Keep away from fire, sparks and heated surfaces. Take necessary action to avoid static electricity discharge (which might cause ignition of organic vapours). Wash hands thoroughly after handling. Open drum carefully as content may be under pressure. In case of mechanical malfunction, or if in contact with unknown dilution of product, wear full Personal Protective Equipment (PPE).
Keep away from heat and sources of ignition. Keep in a cool, well-ventilated place. Keep away from oxidizing agents. Keep out of reach of children. Keep container tightly closed. Store in suitable labeled containers.
Wash hands thoroughly after handling.
Keep away from fire, sparks and heated surfaces. Take necessary action to avoid static electricity discharge (which might cause ignition of organic vapours).
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Effective exhaust ventilation system. Maintain air concentrations below occupational exposure standards.
Recommended preventive skin protection - Gloves - Nitrile rubber - butyl-rubber - Breakthrough time: 1 – 4 hours - Gloves should be discarded and replaced if there is any indication of degradation or chemical breakthrough.
Wear eye protection/face protection.
None required if airborne concentrations are maintained below the exposure limit listed in Exposure Limit Information. Use certified respiratory protection equipment meeting EU requirements(89/656/EEC, (EU) 2016/425), or equivalent, when respiratory risks cannot be avoided or sufficiently limited by technical means of collective protection or by measures, methods or procedures of work organization.
No special protective equipment required.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable under normal conditions.
No dangerous reaction known under conditions of normal use.
No dangerous reaction known under conditions of normal use.
Heat, flames and sparks.
None known.
In case of fire hazardous decomposition products may be produced such as: Carbon oxides
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
Dispose of wastes in an approved waste disposal facility.
Dispose of as unused product.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- UN Number
- 1987
- Shipping Name
- ALCOHOLS, N.O.S. (Isopropanol, Propanol)
- Transport Class
- 3
- Packing Group
- III
Regulatory Information
Chemical regulations, safety assessments, and compliance status
For Regulatory information please contact your Ecolab sales representative.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for SIRAFAN SPEED?
The signal word is warning.
What is the physical form of SIRAFAN SPEED?
SIRAFAN SPEED is a liquid appearing as liquid with clear, colourless color. It has alcohol-like odor.
What is SIRAFAN SPEED used for?
Disinfectant
What are the hazard statements for SIRAFAN SPEED?
This substance has 4 hazard statements:
- H226: Flammable liquid and vapour.
- H315: Causes skin irritation.
- H319: Causes serious eye irritation.
- H336: May cause drowsiness or dizziness.
What is the melting point of SIRAFAN SPEED?
The melting point is no data available and the boiling point is no data available.