NextSDS Logo
Safety Data Sheet EN

Aerosol NC Industrielack uni mattiert, diff colors

Scan your chemical compliance

Free 10-second scan. Upload a document and check compliance instantly.

Scan Now
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Aerosol NC Industrielack uni mattiert, diff colors
Product Code
REZ1399

Regulatory Identifiers

CAS Number
N/A

Identified Uses

SU3 Industrial uses: Uses of substances as such or in preparations at industrial sites SU21 Consumer uses: Private households / general public / consumers SU22 Professional uses: Public domain (administration, education, entertainment, services, craftsmen) painting

Uses advised against

No further relevant information available.

Manufacturers & Suppliers

P

Peter Kwasny GmbH

manufacturer

Heilbronner Str. 96 D-74831 Gundelsheim

0049-(0)6269-95-20

Emergency Contacts

Emergency Contact

+49 6269 95 20

National Poisons Information Service, Birmingham

844 892 0111

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Aerosol Cat. 1 H222
Aerosol Cat. 1 H229
Eye Irrit. Cat. 2 H319
STOT SE Cat. 3 H336

GHS Pictograms

GHS02 - Flammable

GHS02

GHS07 - Health hazard

GHS07

Hazard Statements

H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.

Precautionary Statements

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P103 Read carefully and follow all instructions.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P271 Use only outdoors or in a well-ventilated area.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P312 Call a POISON CENTER/doctor if you feel unwell.
P337 + P313 If eye irritation persists: Get medical advice/attention.
P410 + P412 Protect from sunlight. Do not expose to temperatures exceeding 50 C/122 F.
P501 Dispose of contents/container in accordance with local/regional/national/international regulations.

Manage your Safety Data Sheets

Organize and access chemical safety data with ease

Manage SDS
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Mixture of substances listed below with nonhazardous additions.

Chemical Name CAS Number Concentration Hazardous
N/A --- 25 - 50% Yes
N/A --- 10 - 25% Yes
N/A --- 5 - 10% Yes
N/A --- 5 - 10% Yes
N/A --- 5 - 10% Yes
N/A --- 5 - 10% Yes
N/A --- 2.5 - 5% Yes
N/A --- 2.5 - 5% Yes
N/A --- 1 - 2.5% Yes
N/A --- 1 - 2.5% Yes
N/A --- 1% Yes
N/A --- 1% Yes
N/A --- 1% Yes
N/A --- 1% Yes

For the wording of the listed hazard phrases refer to section 16.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Supply fresh air; consult doctor in case of complaints.

Eye contact

Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.

Ingestion

If symptoms persist consult doctor.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

The data for this section has not been processed yet.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

The data for this section has not been processed yet.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

The data for this section has not been processed yet.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Hands

Protective gloves. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Gloves must be changed after every contamination. The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed. For the permanent contact of a maximum of 15 minutes gloves made of the following materials are suitable: butyl rubber, 0,7mm

Eyes

Safety glasses. Tightly sealed goggles

Respiratory

When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. Half mask with combination filter, class A1P2 minimum, or breathing mask with outer air supply.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Vapor Density
Not determined.
Relative Evaporation Rate
---
Odor
---
Bulk Density
---
Flammability
---
Vapor Pressure
at 20 C: 3,600 hPa; at 50 C: 800 hPa
Molecular Weight
---
Ph
Mixture is non-polar/aprotic.
Solubility In Water
Not miscible or difficult to mix.
Solubility In Fat
---
Explosive Limits
---
Colour Intensity
---
Properties Status
---
Crystallisation Point
---
Solidification Point
---
Metal Corrosion
Void
Melting Point
---
Physical State Data
aerosol
State Under Standard Conditions
---
Colour
---
Voc Content
86.29 %
Form
Aerosol
Evaporation Rate
Not applicable.
Odor Threshold
---
Partition Coefficient
Not determined.
Boiling Point
---
Freezing Point
---
Density
---
Decomposition Temperature
Not determined.
Physical State
---
Dynamic Viscosity
Not determined.
Appearance
---
Flash Point
<0 C
Auto Ignition Temperature
315 C (108-65-6 2-methoxy-1-methylethyl acetate)
Relative Density
0.827 g/cm
Lower Explosive Limit
1.7 Vol %
Cloud Point
---
Upper Explosive Limit
13 Vol %
Softening Point
---
Solubility
---
Kinematic Viscosity
Not determined.
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

The data for this section has not been processed yet.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
UN1950
Packing Group
Void not classified
ADR

Warning: Gases.

IMDG

Warning: Gases.

IATA

Warning: Gases.

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for Aerosol NC Industrielack uni mattiert, diff colors?

The signal word is danger.

What is Aerosol NC Industrielack uni mattiert, diff colors used for?

SU3 Industrial uses: Uses of substances as such or in preparations at industrial sites SU21 Consumer uses: Private households / general public / consumers SU22 Professional uses: Public domain (administration, education, entertainment, services, craftsmen) painting

What are the hazard statements for Aerosol NC Industrielack uni mattiert, diff colors?

This substance has 4 hazard statements:

  • H222: Extremely flammable aerosol.
  • H229: Pressurised container: May burst if heated.
  • H319: Causes serious eye irritation.
  • H336: May cause drowsiness or dizziness.

Compliance Scanner

Scan your compliance