TENSOPOL S30LSK

IF INHALED: Remove to fresh air and keep at rest in a position comfortable for breathing. If breathing is difficult, give oxygen.

Wash off immediately with soap and plenty of water. If a person feels unwell or symptoms of skin irritation appear, consult a physician.

Symptoms: May cause allergic skin reaction. Redness. Swelling of tissue.

Rinse immediately carefully and thoroughly with eye-bath or water. If eye irritation persists, consult a specialist.

Symptoms: Risk of serious damage to eyes.

If swallowed, seek medical advice immediately and show this SDS or label. Do not induce vomiting without medical advice. Never give anything by mouth to an unconscious person.

Use water spray or fog, Alcohol resistant foam, Fire-extinguishing powder, Carbon dioxide, Dry sand

straight streams

No further relevant information available.

Keep people away from and upwind of spill/leak. Product forms slippery surface when combined with water.

Do not allow to enter sewers/ surface or ground water.

Soak up with inert absorbent material, sweep up and shovel into suitable containers for disposal.

Materials: inert absorbent material, suitable containers

Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols. Avoid contact with skin, eyes and clothing. Avoid breathing mists, dusts, or vapors. Wash hands thoroughly after handling.

Keep containers tightly closed in a cool, well-ventilated place. Keep product and empty container away from heat and sources of ignition.

Wash hands thoroughly after handling.

Keep product and empty container away from heat and sources of ignition.

Protective gloves. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves: Neoprene gloves. The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. The determined penetration times according to EN 16523-1:2015 are not performed under practical conditions. Therefore a maximum wearing time, which corresponds to 50% of the penetration time, is recommended.

Tightly sealed goggles

In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.

Slip proof shoes

The substance is stable if stored and handled properly. However, if stored at high temperature (above 50°C or between 40 and 50°C for a long period of time) or in contact with hot spots or if it enters in contact with small amount of strong acid, product may undergo acid hydrolysis and generate sulphuric acid. If this occurs, pH will drop drastically.

No further relevant information available.

No dangerous reactions known.

Temperatures in excess of 50 °C or below 0 °C.

Avoid contact with acids and with strong oxidising agents.

No decomposition at recommended handling temperature. However, in case of extreme hydrolysis (see here above), product may release a corrosive mixture containing sulphuric acid.

Do not contaminate ponds, waterways or ditches with chemical or used container. Dispose of in accordance with federal, state and local regulations.

Dispose of in accordance with federal, state and local regulations.