Mercury(II) chloride for analysis EMSURE® Reag. Ph Eur,ACS

After inhalation: fresh air. Call in physician.

In case of skin contact: Take off immediately all contaminated clothing. Rinse skin with water/ shower. Call a physician immediately.

After eye contact: rinse out with plenty of water. Immediately call in ophthalmologist. Remove contact lenses.

If swallowed: give water to drink (two glasses at most). Seek medical advice immediately. In exceptional cases only, if medical care is not available within one hour, induce vomiting (only in persons who are wide awake and fully conscious), administer activated charcoal (20 - 40 g in a 10% slurry) and consult a doctor as quickly as possible. Do not attempt to neutralise.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

For this substance/mixture no limitations of extinguishing agents are given.

Not combustible. Fire may cause evolution of: mercury vapours, Hydrogen chloride gas, Ambient fire may liberate hazardous vapours.

Suppress (knock down) gases/vapours/mists with a water spray jet.

Avoid generation and inhalation of dusts in all circumstances. Avoid substance contact. Ensure adequate ventilation. Evacuate the danger area, observe emergency procedures, consult an expert.

Do not let product enter drains.

Cover drains. Collect, bind, and pump off spills. Observe possible material restrictions (see sections 7 and 10). Take up carefully. Dispose of properly. Clean up affected area.

Work under hood. Do not inhale substance/mixture.

Protected from light. Tightly closed. Dry. Keep in a well-ventilated place. Keep locked up or in an area accessible only to qualified or authorised persons.

Immediately change contaminated clothing. Apply preventive skin protection. Wash hands and face after working with substance.

Material : Nitrile rubber, Break through time : 480 min, Glove thickness : 0,11 mm, Protective index : Full contact, Manufacturer : KCL 741 Dermatril® L. Splash contact details: Material : Nitrile rubber, Break through time : 480 min, Glove thickness : 0,11 mm, Protective index : Splash contact, Manufacturer : KCL 741 Dermatril® L. Remarks : This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Tightly fitting safety goggles

required when dusts are generated. Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system. Recommended Filter : Filter type P3 type: The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

protective clothing

Do not let product enter drains.

The product is chemically stable under standard ambient conditions (room temperature).

No data available

Risk of explosion with: Fluorine, Alkali metals, hydrazine and derivatives. Exothermic reaction with: Strong bases, Strong oxidizing agents.

Avoid moisture. Light.

Lead, Copper, Light metals, silver, Zinc, Tin

In the event of fire: see section 5