Formic acid 99%

Supply fresh air or oxygen; call for doctor. In case of unconsciousness place patient stably in side position for transportation.

Immediately wash with water and soap and rinse thoroughly.

Rinse opened eye for several minutes under running water. Then consult a doctor.

Call for a doctor immediately. Drink plenty of water and provide fresh air. Call for a doctor immediately.

CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.

During heating or in case of fire poisonous gases are produced.

Mount respiratory protective device. Wear protective equipment. Keep unprotected persons away.

Dilute with plenty of water.

Absorb with liquid-binding material

Materials: sand, diatomite, acid binders, universal binders, sawdust

Do not seal receptacles gas-tight. Avoid contact with skin and eyes. Avoid inhalation of vapour or mist. Keep away from sources of ignition - No smoking. Open and handle receptacle with care. Prevent formation of aerosols.

Store at room temperature in a shaded and ventilated place. May decompose forming gaseous products, especially when stored over long periods. Keep container tightly sealed.

Avoid contact with skin and eyes.

Keep away from open flames, hot surfaces and sources of ignition. Take precautionary measures against static discharge. Keep ignition sources away - Do not smoke. Protect against electrostatic charges.

No further data; see section 7.

Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture. Protective gloves. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves: The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. Penetration time of glove material: The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.

Tightly sealed goggles

In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.

No decomposition if used according to specifications.

No further relevant information available.

No dangerous reactions known.

No decomposition if used according to specifications.

No further relevant information available.

No dangerous decomposition products known.