KODAK RP X-OMAT Developer Replenisher, Part B

If inhaled, remove to fresh air. If not breathing, give artificial respiration using mouth guards or shields, when available, to avoid mouth-to-mouth contact. If breathing is difficult, give oxygen. If experiencing respiratory symptoms: Call a POISON CENTER or doctor/ physician.

In case of contact, immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Call a physician or poison control centre immediately. Wash contaminated clothing before re-use. Destroy or thoroughly clean contaminated shoes.

Immediately flush the contaminated eye(s) with water for at least 60 minutes, while holding the eyelid(s) open. If a contact lens is present, DO NOT delay irrigation or attempt to remove the lens. Neutral saline solution may be used as soon as it is available. DO NOT INTERRUPT FLUSHING. Contact a physician or poison control center immediately. Continue flushing the eye(s) until the physician advises to stop. If necessary, continue flushing during transport to an emergency care facility.

If swallowed, DO NOT induce vomiting. Rinse mouth. Get medical attention immediately.

Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.

No flashpoint in conventional closed cup tester but forms flammable vapour-air mixtures in larger volumes at temperatures above 49°C (120°F). Material contains a combustible solvent that may accumulate in the container headspace.

Use water spray to cool unopened containers.

Refer to protective measures listed in sections 7 and 8.

Contaminated absorbent should be disposed of in accordance with local regulations.

Absorb spill with vermiculite or other inert absorbant material such as sand or earth, then place in a suitable container for proper disposal. Clean surface thoroughly with water to remove residual contamination.

Materials: vermiculite, sand, earth

Avoid breathing mist or vapour. Avoid contact with eyes, skin, and clothing. Wash thoroughly after handling. Use with adequate ventilation.

Cool conditions (5 - 30°C). Keep container tightly closed.

Wash thoroughly after handling.

Keep away from heat and sources of ignition.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions.

Using the information provided in Section 2, seek the advice of the glove supplier as to the most suitable glove material. Avoid skin contact when mixing or handling the substance/preparation or a mixture by wearing impervious gloves and protective clothing appropriate to the risk of exposure. Use chemical resistant gloves. In case of prolonged immersion or frequently repeated contact: Consult your glove manufacturer. Consult your glove manufacturer for advice on what glove material to avoid. The protective gloves to be used must comply with the specifications of the EC directive 89/686/EEC and the resultant standard EN 374. This recommendation applies only to the product stated in the Safety Data Sheet and supplied by us as well as to the purpose specified by us.

Wear safety glasses with side shields (or goggles) and a face shield.

If engineering controls do not maintain airborne concentrations below recommended exposure limits, an approved respirator must be worn. If respirators are used, a program should be instituted to assure compliance with applicable federal, state, commonwealth, provincial, or local laws and regulations.

Avoid skin contact when mixing or handling the substance/preparation or a mixture by wearing impervious gloves and protective clothing appropriate to the risk of exposure.

Stable under normal conditions.

No data available

Hazardous polymerisation does not occur.

No data available

Strong oxidizing agents, Bases, Amines, Metals.

Carbon oxides, Nitrogen oxides (NOx)