Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- Volvo Engine oil VDS-4.5 10W-30
- Product Form
- Liquid
- Product Code
- 23068339S
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
Engine Oil
Uses advised against
Not applicable.
Manufacturers & Suppliers
AB Volvo
manufacturer
SE-405 08 Göteborg, Sweden
+46(0) 31 66 00 00
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
Hazard Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| Mineral Oil, Solvent refined | --- | 90% | Yes |
| Alkyl phenate alkanoate | --- | 5% | Yes |
| reaction mass of isomers of: C7-9-alkyl 3-(3,5-di-tert-butyl-4-hydroxyphenyl) propionate EC: 406-040-9 | 125643-61-0 | 5% | Yes |
| BENZENAMINE, AR-NONYL-N-(NONYLPHENYL)- EC: 253-249-4 | 36878-20-3 | 5% | Yes |
| Zinc alkyl dithiophosphate EC: 298-577-9 | 93819-94-4 | 1.99% | Yes |
| Phosphorodithioic acid, mixed O,O-bis(2-ethylhexyl and iso-Bu and iso-Pr) esters, zinc salts EC: 288-917-4 | 85940-28-9 | 1.99% | Yes |
First Aid Measures
Emergency procedures for chemical exposure incidents
If inhaled, remove to fresh air.
Symptoms: Long term exposure to high concentrations of oil mist or vapors may cause lung damage.
Wash contaminated skin with soap and water. Remove contaminated clothing and wash it before reuse.
Symptoms: Prolonged or repeated contact can defat the skin and lead to irritation, cracking and/or dermatitis.
In case of contact with eyes, rinse immediately with plenty of water. Remove contact lenses, if present and easy to do.
Symptoms: May cause slight transient irritation. (redness)
If swallowed, do not induce vomiting.
Symptoms: Ingestion may cause gastrointestinal irritation and diarrhea.
Immediate Medical Attention
Get medical attention.
Medical Treatment
No specific treatment.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Recommended:, CO₂, powders, Foam
Do not use water jet.
In a fire or if heated, a pressure increase will occur and the container may burst.
Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire.
Firefighter Protection
Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
For non-emergency personnel : Refer to protective measures listed in sections 7 and 8. For emergency responders : If specialized clothing is required to deal with the spillage, take note of any information in Section 8 on suitable and unsuitable materials. See also the information in "For non-emergency personnel".
Stop leak if without risk. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations.
Stop leak if without risk. Move containers from spill area. Prevent entry into sewers, water courses, basements or confined areas. Wash spillages into an effluent treatment plant or proceed as follows. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations. Dispose of via a licensed waste disposal contractor.
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers.
Contain and collect spillage with non-combustible, absorbent material.
Materials: sand, earth, vermiculite or diatomaceous earth
Related Products
Similar products with comparable safety profiles
Engine oil VDS-3 15W-40
---
Axle Oil Volvo 97317 75W-80 G0102
---
Valvoline™ Non-Detergent SAE 30 ISO 100 Motor Oil
---
Engine Oil 5W-30 C2 F
---
Valvoline™ Advanced Full Synthetic SAE 10W-30 Motor Oil
---
Castrol Garden 4T 10W-30
---
ENGINE POWER 10W/30
---
DOOSAN ENGINE POWER 10W30 CI-4
---
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Put on appropriate personal protective equipment (see Section 8). Avoid prolonged or repeated contact with skin. Avoid inhalation of vapor, spray or mist. Materials such as rags used with this product may begin to burn by themselves.
Keep container in a cool, well-ventilated area. Keep container tightly closed.
Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Wash contaminated clothing before reuse.
Take precautionary measures against electrostatic discharges.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Use only with adequate ventilation. If this product contains ingredients with exposure limits, use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure below any recommended or statutory limits. Where reasonably practicable, this should be achieved by the use of local exhaust ventilation and good general extraction. Drain down system prior to equipment break-in or maintenance.
For prolonged or repeated handling, use gloves: > 8 hours (breakthrough time): nitrile, neoprene rubber, PVC. gloves thickness >0.35 mm Wear suitable gloves tested to EN374.
Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases or dusts.
Provide adequate ventilation. A respirator is not needed under normal and intended conditions of product use. If workers are exposed to concentrations above the exposure limit, they must use appropriate, certified respirators. Type A/P, EN14387 & EN143.
Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Appropriate footwear and any additional skin protection measures should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product.
Do not allow to enter drains or watercourses.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable under recommended storage and handling conditions (see Section 7).
No specific test data related to reactivity available for this product or its ingredients.
Under normal conditions of storage and use, hazardous reactions will not occur.
Keep away from heat and direct sunlight.
Strong oxidizing materials
Under normal conditions of storage and use, hazardous decomposition products should not be produced.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
Transport within user's premises: always transport in closed containers that are upright and secure. Ensure that persons transporting the product know what to do in the event of an accident or spillage.
Transport within user's premises: always transport in closed containers that are upright and secure. Ensure that persons transporting the product know what to do in the event of an accident or spillage.
Transport within user's premises: always transport in closed containers that are upright and secure. Ensure that persons transporting the product know what to do in the event of an accident or spillage.
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for Volvo Engine oil VDS-4.5 10W-30?
The signal word is no signal word.
What is the physical form of Volvo Engine oil VDS-4.5 10W-30?
Volvo Engine oil VDS-4.5 10W-30 is a liquid with amber color. It has petroleum oil odor.
What is Volvo Engine oil VDS-4.5 10W-30 used for?
Engine Oil
What are the hazard statements for Volvo Engine oil VDS-4.5 10W-30?
This substance has 1 hazard statement:
- No known significant effects or critical hazards.
What is the melting point of Volvo Engine oil VDS-4.5 10W-30?
The melting point is Not available. and the boiling point is >280°C (>536°F).