NextSDS Logo
Safety Data Sheet EN

Engine Oil VDS-4.5 15W-40

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Engine Oil VDS-4.5 15W-40
Product Form
Liquid
Product Code
23909460

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Oil

Uses advised against

Not applicable.

Manufacturers & Suppliers

A

AB Volvo Penta

manufacturer

SE-405 08 Göteborg, Sweden

+46 (0)31 23 54 60

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified no signal word

Hazard Classifications

Not Classified

GHS Pictograms

Hazard Statements

No known significant effects or critical hazards.

Precautionary Statements

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Anti-oxidant (Phenolic) EC: 406-040-9 125643-61-0 3% Yes
Mineral Oil, Solvent refined --- 70 - 100% Yes
BENZENAMINE, AR-NONYL-N-(NONYLPHENYL)- EC: 253-249-4 36878-20-3 3% Yes
zinc bis[O-(6-methylheptyl)] bis[O-(sec-butyl)] bis (dithiophosphate) EC: 298-577-9 93819-94-4 2.5% Yes
Alkyl Phenol EC: 310-154-3 121158-58-5 0.3% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

If inhaled, remove to fresh air.

Symptoms: Long term exposure to high concentrations of oil mist or vapors may cause lung damage.

Skin contact

Wash contaminated skin with soap and water.

Symptoms: Repeated or prolonged contact with the mixture may cause removal of natural fat from the skin, resulting in non-allergic contact dermatitis and absorption through the skin.

Eye contact

In case of contact with eyes, rinse immediately with plenty of water. Continue to rinse for at least 10 minutes.

Symptoms: May cause slight transient irritation. (redness)

Ingestion

If ingested, do not induce vomiting.

Symptoms: Ingestion may cause gastrointestinal irritation and diarrhea.

Immediate Medical Attention

Get medical attention.

Medical Treatment

No specific treatment.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Recommended:, CO₂, powders, Foam

Unsuitable media

Do not use water jet.

Specific hazards

In a fire or if heated, a pressure increase will occur and the container may burst.

Instructions

Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire.

Firefighter Protection

Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

For non-emergency personnel: Refer to protective measures listed in sections 7 and 8. For emergency responders: If specialized clothing is required to deal with the spillage, take note of any information in Section 8 on suitable and unsuitable materials. See also the information in 'For non-emergency personnel'.

Small spill

Stop leak if without risk. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations.

Large spill

Stop leak if without risk. Move containers from spill area. Prevent entry into sewers, water courses, basements or confined areas. Wash spillages into an effluent treatment plant or proceed as follows. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations. Dispose of via a licensed waste disposal contractor.

Environmental

Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers.

Cleanup methods

Contain and collect spillage with non-combustible, absorbent material and place in container for disposal according to local regulations.

Materials: sand, earth, vermiculite or diatomaceous earth

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Put on appropriate personal protective equipment (see Section 8).

Storage

Keep container in a cool, well-ventilated area.

Hygiene

Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Wash contaminated clothing before reuse. See also Section 8 for additional information on hygiene measures.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Use only with adequate ventilation. If this product contains ingredients with exposure limits, use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure below any recommended or statutory limits. Where reasonably practicable, this should be achieved by the use of local exhaust ventilation and good general extraction.

Hands

For prolonged or repeated handling, use gloves : nitrile rubber

Eyes

Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases or dusts.

Respiratory

Provide adequate ventilation.

Skin/Body

Body protection : Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Other skin protection : Appropriate footwear and any additional skin protection measures should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product.

Environmental

Do not allow to enter drains or watercourses.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Softening Point
---
Voc Content
---
Odor Threshold
Not available.
Molecular Weight
---
Auto Ignition Temperature
Not available.
State Under Standard Conditions
---
Upper Explosive Limit
10%
Kinematic Viscosity
Kinematic (40°C): 115 mm²/s
Solubility In Water
Not available.
Solubility
---
Explosive Limits
---
Cloud Point
---
Relative Evaporation Rate
---
Freezing Point
---
Decomposition Temperature
Not available.
Evaporation Rate
Not available.
Ph
Not applicable.
Solidification Point
---
Boiling Point
>280°C (>536°F)
Melting Point
Not available.
Physical State Data
liquid
Flammability
---
Physical State
Liquid.
Bulk Density
---
Partition Coefficient
Not applicable.
Colour Intensity
---
Flash Point
Open cup: 236°C (456.8°F) [ASTM D92 Cleveland]
Colour
Amber.
Solubility In Fat
---
Crystallisation Point
---
Dynamic Viscosity
---
Form
---
Relative Density
0.876
Odor
Slight Hydrocarbon.
Vapor Density
Not available.
Properties Status
---
Vapor Pressure
Not available.
Lower Explosive Limit
1%
Appearance
---
Density
0.876 g/cm³ [15°C (59°F)]
Metal Corrosion
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under recommended storage and handling conditions (see Section 7).

Reactivity

No specific test data related to reactivity available for this product or its ingredients.

Hazardous reactions

Under normal conditions of storage and use, hazardous reactions will not occur.

Avoid

No specific data.

Incompatible

No specific data.

Decomposition

Under normal conditions of storage and use, hazardous decomposition products should not be produced.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for Engine Oil VDS-4.5 15W-40?

The signal word is no signal word.

What is the physical form of Engine Oil VDS-4.5 15W-40?

Engine Oil VDS-4.5 15W-40 is a liquid. with amber. color. It has slight hydrocarbon. odor.

What is Engine Oil VDS-4.5 15W-40 used for?

Oil

What are the hazard statements for Engine Oil VDS-4.5 15W-40?

This substance has 1 hazard statement:

  • No known significant effects or critical hazards.

What is the melting point of Engine Oil VDS-4.5 15W-40?

The melting point is Not available. and the boiling point is >280°C (>536°F).