Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- Engine oil VDS-3 15W-40
- Product Form
- Liquid.
- Product Code
- 23909457
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
Motor oils
Manufacturers & Suppliers
AB Volvo
manufacturer
SE-405 08 Göteborg, Sweden
http://websds.volvo.com
Emergency Contacts
Emergency Contact
+46-31-66 67 50
during office hours
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
Hazard Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
There are no additional ingredients present which, within the current knowledge of the supplier and in the concentrations applicable, are classified as hazardous to health or the environment and hence require reporting in this section.
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| zinc bis[O-(6-methylheptyl)] bis[O-(sec-butyl)] bis (dithiophosphate) EC: 298-577-9 | 93819-94-4 | 2.5% | Yes |
| Phosphorodithioic acid, mixed O,O-bis(sec-Bu and 1,3-dimethylbutyl) esters, zinc salts EC: 272-238-5 | 68784-31-6 | 2.5% | Yes |
| Benzenesulfonic acid, methyl-, mono-C20-24-branched alkyl derivs., calcium salts | 722503-68-6 | 1% | Yes |
| Benzenesulfonic acid, methyl-, mono-C20-26-branched alkyl derivs., calcium salts | 722503-69-7 | 1% | Yes |
| Alkyl phenol EC: 310-154-3 | 121158-58-5 | 0.25% | Yes |
| Mineral Oil, Solvent refined | --- | 90% | Yes |
Occupational exposure limits, if available, are listed in Section 8.
Notes
There are no additional ingredients present which, within the current knowledge of the supplier and in the concentrations applicable, are classified as hazardous to health or the environment and hence require reporting in this section.
First Aid Measures
Emergency procedures for chemical exposure incidents
If inhaled, remove to fresh air.
Symptoms: May cause slight transient irritation.
Wash contaminated skin with soap and water.
Symptoms: Defatting to the skin. Prolonged or repeated contact can defat the skin and lead to irritation, cracking and/or dermatitis. Contains small percentage of substances which can cause allergic reactions.
In case of contact with eyes, rinse immediately with plenty of water.
Symptoms: May cause slight transient irritation. ( redness )
Get medical attention. If ingested, do not induce vomiting.
Symptoms: Ingestion may cause gastrointestinal irritation and diarrhoea.
Immediate Medical Attention
Get medical attention.
Medical Treatment
Treat symptomatically.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Recommended: CO₂, powders, Foam
Do not use water jet.
In a fire or if heated, a pressure increase will occur and the container may burst.
Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire.
Firefighter Protection
Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Stop leak if without risk.
Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers.
Contain and collect spillage with non-combustible, absorbent material and place in container for disposal according to local regulations.
Materials: non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Put on appropriate personal protective equipment (see Section 8).
Do not store in unlabelled containers. Keep container tightly closed. Keep container in a cool, well-ventilated area.
Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Wash contaminated clothing before reuse.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Use only with adequate ventilation. Where reasonably practicable, this should be achieved by the use of local exhaust ventilation and good general extraction. If workers are exposed to concentrations above the exposure limit, they must use appropriate, certified respirators.
> 8 hours (breakthrough time): nitrile
Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases or dusts.
Provide adequate ventilation.
Do not allow to enter drains or watercourses.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable under recommended storage and handling conditions (see Section 7).
No specific test data related to reactivity available for this product or its ingredients.
Reactive with: Oxidising agents
Keep away from heat and direct sunlight.
Reactive or incompatible with the following materials: oxidizing materials
Under normal conditions of storage and use, hazardous decomposition products should not be produced.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
Waste must be disposed of in accordance with federal, state and local environmental control regulations.
Waste Codes
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
Regulatory Information
Chemical regulations, safety assessments, and compliance status
Product use: Consumer applications, Industrial applications.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for Engine oil VDS-3 15W-40?
The signal word is no signal word.
What is the physical form of Engine oil VDS-3 15W-40?
Engine oil VDS-3 15W-40 is a liquid. appearing as liquid. amber. with amber. color. It has petroleum oil odor.
What is the solubility of Engine oil VDS-3 15W-40?
Insoluble in the following materials: cold water and hot water.
What is Engine oil VDS-3 15W-40 used for?
Motor oils
What are the hazard statements for Engine oil VDS-3 15W-40?
This substance has 1 hazard statement:
- No known significant effects or critical hazards.
What is the melting point of Engine oil VDS-3 15W-40?
The melting point is Not available. and the boiling point is >280°C (>536°F).