Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- Volvo Automatic Transmission Fluid AT102
- Product Form
- Liquid
- Product Code
- 15142868
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
Transmission fluids
Uses advised against
Not applicable.
Manufacturers & Suppliers
Volvo Construction Equipment AB
manufacturer
Customer Support Division, SE-631 85 Eskilstuna, Sweden
+46(0) 31 66 00 00
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
Hazard Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| Distillates (petroleum), hydrotreated light paraffinic; Baseoil - unspecified EC: 265-158-7 | 64742-55-8 | 30 - 40% | Yes |
| Methacrylate polymer | --- | 5% | Yes |
| N,N-Dimethyloctadecylamine EC: 204-694-8 | 124-28-7 | 0.1% | Yes |
| Oleylimidazolin EC: 202-414-9 | 95-38-5 | 0.1% | Yes |
| 2,2'-(C16-18 (evennumbered, C18 unsaturated) alkyl imino) diethanol EC: 620-540-6 | 1218787-32-6 | 0.1% | Yes |
First Aid Measures
Emergency procedures for chemical exposure incidents
If inhaled, remove to fresh air.
Symptoms: Long term exposure to high concentrations of oil mist or vapors may cause lung damage.
Wash contaminated skin with soap and water.
Symptoms: Prolonged or repeated contact can defat the skin and lead to irritation, cracking and/or dermatitis.
In case of contact with eyes, rinse immediately with plenty of water.
Symptoms: May cause slight transient irritation. (redness)
If swallowed, do not induce vomiting.
Symptoms: Ingestion may cause gastrointestinal irritation and diarrhoea.
Immediate Medical Attention
Get medical attention.
Medical Treatment
No specific treatment.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Recommended:, CO₂, powders, Foam
Do not use water jet.
In a fire or if heated, a pressure increase will occur and the container may burst.
Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire.
Firefighter Protection
Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
For non-emergency personnel : Refer to protective measures listed in sections 7 and 8. For emergency responders : If specialised clothing is required to deal with the spillage, take note of any information in Section 8 on suitable and unsuitable materials. See also the information in "For non-emergency personnel".
Stop leak if without risk. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations.
Stop leak if without risk. Move containers from spill area. Prevent entry into sewers, water courses, basements or confined areas. Wash spillages into an effluent treatment plant or proceed as follows. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations. Dispose of via a licensed waste disposal contractor.
Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers.
Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations.
Materials: sand, earth, vermiculite or diatomaceous earth
Related Products
Similar products with comparable safety profiles
Volvo Engine oil VDS-4.5 10W-30
---
Axle Oil Volvo 97317 75W-80 G0102
---
Coastal DexMerc Automatic Transmission Fluid
---
TOTAL TRANSMISSION TM 80W-90 and 85W-140
---
WOLF VITALTECH ATF D III
---
NAPA® PREM PERF Automatic Transmission Fluid
---
DEVELON AXLE/TRANSMISSION 10W-30
---
FCA ULV ATF
---
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Put on appropriate personal protective equipment (see Section 8).
Keep container in a cool, well-ventilated area. Keep container tightly closed.
Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Wash contaminated clothing before reuse. See also Section 8 for additional information on hygiene measures.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Use only with adequate ventilation. If this product contains ingredients with exposure limits, use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure below any recommended or statutory limits. Where reasonably practicable, this should be achieved by the use of local exhaust ventilation and good general extraction.
Not needed under normal and intended conditions of product use. For prolonged or repeated handling, use gloves : nitrile
Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases or dusts.
Provide adequate ventilation.
Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Appropriate footwear and any additional skin protection measures should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product.
Do not allow to enter drains or watercourses.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable under recommended storage and handling conditions (see Section 7).
No specific test data related to reactivity available for this product or its ingredients.
Under normal conditions of storage and use, hazardous reactions will not occur.
Keep away from heat. Avoid all possible sources of ignition (spark or flame).
Reactive or incompatible with the following materials: oxidising materials
Under normal conditions of storage and use, hazardous decomposition products should not be produced.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for Volvo Automatic Transmission Fluid AT102?
The signal word is no signal word.
What is the physical form of Volvo Automatic Transmission Fluid AT102?
Volvo Automatic Transmission Fluid AT102 is a liquid. with red. color. It has petroleum oil odor.
What is Volvo Automatic Transmission Fluid AT102 used for?
Transmission fluids
What are the hazard statements for Volvo Automatic Transmission Fluid AT102?
This substance has 1 hazard statement:
- No known significant effects or critical hazards.
What is the melting point of Volvo Automatic Transmission Fluid AT102?
The melting point is Not available. and the boiling point is >316°C (>600.8°F).