Macropoxy® Poxicolor Comp. A

If unconscious, place in recovery position and seek medical advice. If symptoms persist, call a physician.

Symptoms: Mucous membrane and respiratory system irritation, headache, dizziness, fatigue, muscular weakness, drowsiness and, in extreme cases, loss of consciousness.

If skin irritation persists, call a physician. If on skin, rinse well with water. If on clothes, remove clothes.

Symptoms: Skin irritation, allergic skin reaction, removal of natural fat from the skin, resulting in non-allergic contact dermatitis.

Immediately flush eye(s) with plenty of water. Remove contact lenses. Protect unharmed eye. Keep eye wide open while rinsing. If eye irritation persists, consult a specialist.

Symptoms: Irritation and reversible damage, serious eye irritation.

Keep respiratory tract clear. Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician.

Alcohol-resistant foam, Carbon dioxide (CO2), Dry chemical

High volume water jet

Do not allow run-off from fire fighting to enter drains or water courses.

Use a water spray to cool fully closed containers.

Use personal protective equipment. Remove all sources of ignition. Evacuate personnel to safe areas. Beware of vapors accumulating to form explosive concentrations. Vapors can accumulate in low areas.

Prevent product from entering drains. Prevent further leakage or spillage if safe to do so.

Contain spillage, and then collect with non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite) and place in container for disposal according to local / national regulations (see section 13).

Materials: non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite)

Good housekeeping standards, regular safe removal of waste materials and regular maintenance of spray booth filters will minimise the risks of spontaneous combustion and other fire hazards. Avoid formation of aerosol. Do not breathe vapors/dust. Avoid exposure - obtain special instructions before use. Avoid contact with skin and eyes. For personal protection see section 8. Smoking, eating and drinking should be prohibited in the application area. Take precautionary measures against static discharges. Provide sufficient air exchange and/or exhaust in work rooms. Open drum carefully as content may be under pressure. Dispose of rinse water in accordance with local and national regulations. Persons susceptible to skin sensitization problems or asthma, allergies, chronic or recurrent respiratory disease should not be employed in any process in which this mixture is being used.

Keep container tightly closed in a dry and well-ventilated place. Containers which are opened must be carefully resealed and kept upright to prevent leakage.

When using do not eat or drink. When using do not smoke. Wash hands before breaks and at the end of workday.

Do not spray on a naked flame or any incandescent material. Take necessary action to avoid static electricity discharge (which might cause ignition of organic vapors). Keep away from open flames, hot surfaces and sources of ignition.

General and local exhaust ventilation is recommended to maintain vapor exposures below recommended limits.

Chemical resistant gloves made of butyl rubber or nitrile rubber category III according to EN 374. Standard glove type. Equipment should conform to EN 374. Protective equipment only chosen according to specific regulatory requirements after a risk assessment. Follow the instructions for use issued by the producer. Gloves should be discarded and replaced if there is any indication of degradation or chemical breakthrough. Be aware that in daily use the durability of a chemical resistant protective glove can be notably shorter than the break through time measured according to EN 374, due to the numerous outside influences (e.g. temperature). The choice of an appropriate glove does not only depend on its material but also on other quality features and is different from one producer to the other. Barrier creams may help to protect the exposed areas of skin, they should however not be applied once exposure has occurred. The suitability for a specific workplace should be discussed with the producers of the protective gloves.

Eye wash bottle with pure water. Safety glasses with side-shields conforming to EN166. Tightly fitting safety goggles. Wear face-shield and protective suit for abnormal processing problems.

Equipment should conform to EN 14387. Where concentrations are above recommended limits or are unknown, appropriate respiratory protection should be worn. Follow OSHA respirator regulations (29 CFR 1910.134) and use NIOSH/MSHA approved respirators. Protection provided by air purifying respirators against exposure to any hazardous chemical is limited. Use a positive pressure air supplied respirator if there is any potential for uncontrolled release, exposure levels are unknown, or any other circumstance where air purifying respirators may not provide adequate protection. When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. Filter type : Combined particulates and organic vapor type (A-P).

Protective equipment only chosen according to specific regulatory requirements after a risk assessment. Equipment should conform to EN 14605. Impervious clothing. Choose body protection according to the amount and concentration of the dangerous substance at the work place.

The product should not be allowed to enter drains, water courses or the soil.

No decomposition if stored and applied as directed.

No hazards to be specially mentioned.

No dangerous reaction known under conditions of normal use.

Temperatures greater than recommended storage temperature. Heat, flames and sparks.

Strong acids and strong bases, Strong oxidizing agents

Carbon dioxide (CO2), carbon monoxide (CO), oxides of nitrogen (NOx), dense black smoke.