Amberlite® IRA-200C (Na), ion exchange resin

Remove to fresh air.

Wash off immediately with plenty of water for at least 15 minutes.

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes.

Clean mouth with water and drink afterwards plenty of water.

Carbon dioxide (CO₂). Powder. Water spray.

No information available.

Risk of explosion.

Fight fire remotely due to the risk of explosion.

Should not be released into the environment. See Section 12 for additional Ecological Information.

Sweep up and shovel into suitable containers for disposal.

Wear personal protective equipment/face protection. Ensure adequate ventilation. Avoid contact with skin, eyes or clothing. Avoid ingestion and inhalation. Avoid dust formation.

Keep container tightly closed in a dry and well-ventilated place.

Handle in accordance with good industrial hygiene and safety practice. Keep away from food, drink and animal feeding stuffs. Do not eat, drink or smoke when using this product. Remove and wash contaminated clothing and gloves, including the inside, before re-use. Wash hands before breaks and after work.

Ensure adequate ventilation, especially in confined areas. Wherever possible, engineering control measures such as the isolation or enclosure of the process, the introduction of process or equipment changes to minimise release or contact, and the use of properly designed ventilation systems, should be adopted to control hazardous materials at source

Protective gloves. Glove material: Butyl rubber. Breakthrough time: See manufacturers recommendations. Glove thickness: -. EU standard: EN 374. Glove comments: (minimum requirement)

Wear safety glasses with side shields (or goggles) (European standard - EN 166)

When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. To protect the wearer, respiratory protective equipment must be the correct fit and be used and maintained properly. Large scale/emergency use: In case of insufficient ventilation, wear suitable respiratory equipment. Recommended Filter type: Particle filter. Small scale/Laboratory use: Use a NIOSH/MSHA or European Standard EN 149:2001 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. When RPE is used a face piece Fit Test should be conducted

Long sleeved clothing. Inspect gloves before use. observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. (Refer to manufacturer/supplier for information) gloves are suitable for the task: Chemical compatibility, Dexterity, Operational conditions, User susceptibility, e.g. sensitisation effects, also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion. gloves with care avoiding skin contamination.

No information available.

Stable under normal conditions.

None known, based on information available

None under normal processing. Hazardous Polymerization No information available.

Incompatible products. Excess heat.

Oxidizing agent.

Sodium oxides.