NUCLISENS EASYMAG LYSIS BUFFER / NUCLISENS LYSIS BUFFER

Get medical attention immediately. Remove victim to fresh air and keep at rest in a position comfortable for breathing. Oxygen or artificial respiration if needed. Do not use mouth-to-mouth method if victim inhaled the substance. Call a physician if symptoms develop or persist.

Symptoms: Irritation of mucous membranes.

Take off immediately all contaminated clothing. Immediately flush skin with plenty of water. For minor skin contact, avoid spreading material on unaffected skin. Get medical attention if irritation develops and persists.

Symptoms: Skin irritation.

Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Call a physician or poison control centre immediately.

Symptoms: Irritation of eyes.

Rinse mouth. If vomiting occurs, keep head low so that stomach content doesn't get into the lungs. Do not use mouth-to-mouth method if victim ingested the substance.

Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).

Do not use water jet as an extinguisher, as this will spread the fire.

Fire may produce irritating, corrosive and/or toxic gases.

Move containers from fire area if you can do so without risk. Use standard firefighting procedures and consider the hazards of other involved materials.

Keep unnecessary personnel away. Wear appropriate protective equipment and clothing during clean-up. Avoid inhalation of vapours and spray mists. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ventilate closed spaces before entering them.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.

Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all environmental releases. Prevent further leakage or spillage if safe to do so.

Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: vermiculite, dry sand or earth, absorbent material (e.g. cloth, fleece)

Avoid inhalation of vapours and spray mists. Avoid contact with eyes, skin, and clothing.

Keep container tightly closed. Store in a well-ventilated place.

Wash hands thoroughly after handling. Observe good industrial hygiene practices.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Eye wash facilities and emergency shower must be available when handling this product.

Wear protective gloves. Use protective gloves made of: Nitrile.

Face shield is recommended. Wear safety glasses with side shields (or goggles).

Respiratory protection not required.

Wear suitable protective clothing. Wear protective gloves.

Inform appropriate managerial or supervisory personnel of all environmental releases.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

No dangerous reaction known under conditions of normal use.

Contact with incompatible materials.

Acids.

No hazardous decomposition products are known.

Read safety instructions, SDS and emergency procedures before handling.

Read safety instructions, SDS and emergency procedures before handling.

Read safety instructions, SDS and emergency procedures before handling.