POLYGARD DE-ICER CONCENTRATE (-20°C)

Place unconscious person on their side in the recovery position and ensure breathing can take place. When breathing is difficult, properly trained personnel may assist affected person by administering oxygen. Get medical attention if any discomfort continues.

Symptoms: This is unlikely to occur but symptoms similar to those of ingestion may develop. In case of overexposure, organic solvents may depress the central nervous system causing dizziness and intoxication, and at very high concentrations unconsciousness and death.

Immediately remove contaminated clothing. Rinse immediately with plenty of water. Remove contaminated clothing.

Symptoms: Skin irritation.

Remove any contact lenses and open eyelids wide apart. Continue to rinse for at least 15 minutes. Get medical attention promptly if symptoms occur after washing.

Symptoms: May cause blurred vision and serious eye damage.

Rinse mouth thoroughly with water. Give plenty of water to drink. Give milk instead of water if readily available. Keep affected person under observation. Do not induce vomiting. If vomiting occurs, the head should be kept low so that vomit does not enter the lungs. Get medical attention immediately. Show this Safety Data Sheet to the medical personnel.

Symptoms: May cause unconsciousness, blindness and possibly death.

Alcohol-resistant foam. Carbon dioxide (CO2). Dry chemicals, sand, dolomite etc. Do not use water, if avoidable.

Do not use water jet as an extinguisher, as this will spread the fire.

The product is flammable. Heating may generate flammable vapours. Thermal decomposition or combustion products may include the following substances: Toxic gases or vapours.

Avoid breathing fire gases or vapours.

Spillages or uncontrolled discharges into watercourses must be reported immediately to the Environmental Agency or other appropriate regulatory body.

Collect and place in suitable waste disposal containers and seal securely.

Materials: vermiculite, dry sand or earth

Keep away from heat, sparks and open flame. Do not wear contact lenses. Avoid spilling. Eye wash facilities and emergency shower must be available when handling this product. During application and drying, solvent vapours will be emitted. Avoid contact with skin and eyes.

Store in tightly-closed, original container in a dry and cool place. Store under well-ventilated conditions at a temperature below 25°C.

Do not wear contact lenses.

Keep away from heat, sparks and open flame.

Provide adequate general and local exhaust ventilation. Observe any occupational exposure limits for the product or ingredients.

Chemical-resistant, impervious gloves complying with an approved standard should be worn if a risk assessment indicates skin contact is possible. In case of intensive contact, wear protective gloves (EN 374). Adhere to the manufacturer's instructions and information relating to the use, storage, care and replacement of protective gloves. protective gloves shall be replaced immediately when physically damaged or worn. Appropriate Material - Butyl, Material Thickness - 0.6 to 0.8mm, Breakthrough Time - 8Hrs

Contact lenses should not be worn when working with this chemical. The following protection should be worn: Chemical splash goggles.

If ventilation is inadequate, suitable respiratory protection must be worn. Wear a respirator fitted with the following cartridge: Gas filter, type A2.

Wear appropriate clothing to prevent any possibility of liquid contact and repeated or prolonged vapour contact.

Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation. In some cases, fume scrubbers, filters or engineering modifications to the process equipment will be necessary to reduce emissions to acceptable levels.

No particular stability concerns. Stable at normal ambient temperatures and when used as recommended.

There are no known reactivity hazards associated with this product.

Not applicable. Will not polymerise.

Avoid heat, flames and other sources of ignition.

Acids. Oxidising agents.

Oxides of carbon. Thermal decomposition or combustion may liberate carbon oxides and other toxic gases or vapours.