THREAD-EZE ULTRA

Remove victim to fresh air.

Symptoms: respiratory irritation, difficulty breathing

Wipe away material with a cloth, and wash with soap and water.

Symptoms: irritation

Rinse the eyes with water. Remove any contact lenses and continue flushing with plenty of water for several minutes.

Symptoms: irritation

Give water if swallowed, but do not induce vomiting. Give water again if vomiting occurs.

Symptoms: discomfort

Use foam, dry chemical, CO₂ or water spray to extinguish fire. Extinguishing media should be chosen based on the nature of the surrounding fire.

Don't use a water jet as this will just spread the fire.

Spills may be slippery. The use of water spray (fog) whilst effective, may cause frothing and foaming.

Cool fire-exposed containers with water spray to prevent bursting.

For small spills, wipe with a cloth and transfer material into a properly labelled container for disposal.

For larger spills, scoop up material into container.

Prevent spill product from contaminating soil or entering sewerage and drainage systems and bodies of water.

Area and residue can be flushed with water.

Materials: cloth

Observe precautions stated on product label, and follow industry safety regulations.

Store material indoors in its original, closed container when not in use. Store at temperatures under 49°C. Keep product from freezing. Do not pressurise, cut, weld, solder, drill, grind, or expose empty containers to heat, hot surfaces, sparks, or open flames.

Do not pressurise, cut, weld, solder, drill, grind, or expose empty containers to heat, hot surfaces, sparks, or open flames.

General ventilation is usually adequate. Local ventilation is recommended to control exposure from operations that generate levels of oil mist in excess of the ASCC exposure recommendation.

Neoprene or nitrile rubber gloves if repeated or prolonged skin contact is likely. Refer to AS/NZS 2161 for information on glove selection.

Whilst none is required under normal conditions of use, safety glasses should be worn if the method of application presents the likelihood of eye contact. AS1336 and AS/NZS1337 should be consulted for information on eye protection.

None required under normal conditions of use. For concentrations above the exposure standards outlined, an approved half-facepiece respirator equipped with appropriate chemical cartridges may be used. Reference should be made to Australian Standards AS/NZS 1715 – ‘Selection, Use and Maintenance of Respiratory Protective Devices’; and AS/NZS 1716 – 'Respiratory Protective Devices.'

Wear general-duty work clothes and enclosed shoes. Refer to AS/NZS 2210 for advice on Occupational Protective Footwear.

Stable.

Will not occur.

Strong oxidising agents such as chlorine bleach and concentrated hydrogen peroxide; strong acids and bases; heated magnesium; chlorinated rubber.

Strong oxidising agents such as chlorine bleach and concentrated hydrogen peroxide; strong acids and bases; heated magnesium; chlorinated rubber.

oxides of carbon and zinc and various hydrocarbons.