Silicone IND

Remove person to fresh air and keep comfortable for breathing. If signs/symptoms develop, get medical attention.

Wash skin with plenty of water. Take off contaminated clothing. If skin irritation occurs: Get medical advice/attention. Seek medical attention if irritation develops.

Symptoms: Irritation.

Rinse eyes with water as a precaution. Seek medical attention if irritation develops.

Do not induce vomiting. Call a physician immediately. Rinse mouth. If vomiting occurs, keep head low so that stomach content doesn't get into the lungs.

Symptoms: Risk of lung oedema.

Water spray. Dry powder. Foam. Carbon dioxide.

Do not use a heavy water stream.

Extremely flammable aerosol. Pressurised container: May burst if heated.

Move containers from fire area if it can be done without personal risk. Use standard firefighting procedures and consider the hazards of other involved materials.

Ventilate spillage area. No open flames, no sparks, and no smoking. Avoid breathing dust/fume/gas/mist/vapours/spray. Avoid contact with skin and eyes. Evacuate unnecessary personnel.

Take up small spills with dry chemical absorbent.

confine the spill in a dike and charge it with wet sand or earth for subsequent safe disposal. Following product recovery, flush area with water.

Avoid release to the environment.

Mechanically recover the product. Clean surface thoroughly to remove residual contamination.

Materials: dry chemical absorbent

Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Use only outdoors or in a well-ventilated area. Avoid breathing dust/fume/gas/mist/vapours/spray. Avoid contact with skin and eyes. Wear personal protective equipment. Avoid prolonged exposure. Handle in accordance with good industrial hygiene and safety procedures.

Protect from sunlight. Do not expose to temperatures exceeding 50 °C/ 122 °F. Store locked up. Store in a well-ventilated place. Keep container tightly closed. Keep cool. Keep container closed when not in use.

Wash contaminated clothing before reuse. Do not eat, drink or smoke when using this product. Always wash hands after handling the product.

Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use.

Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level.

Wear suitable gloves tested to EN374. The breakthrough time of the glove should be longer than the total duration of product use. If work lasts longer than the breakthrough time, gloves should be changed part-way through. Nitrile gloves are recommended.

Use eye protection according to EN 166. Safety glasses with side shields.

In case of insufficient ventilation, wear suitable respiratory equipment. Approved organic vapour respirator. Filter type: AX

Wear suitable protective clothing

Avoid release to the environment. Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation.

Stable under normal conditions.

Extremely flammable aerosol. Pressurised container: May burst if heated.

No dangerous reactions known under normal conditions of use.

Avoid contact with hot surfaces. Heat. No flames, no sparks. Eliminate all sources of ignition.

Strong oxidizing agents.

Under normal conditions of storage and use, hazardous decomposition products should not be produced. Carbon oxides (CO, CO2).