EHPD 15W-40

If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing.

Symptoms: May cause irritation

Remove contaminated clothing immediately and drench affected skin with plenty of water. Then wash with soap and water.

Symptoms: May cause redness and irritation

Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.

Symptoms: May cause redness and irritation

Do NOT induce vomiting.

Symptoms: May cause gastro-intestinal disturbances

water spray or fog, alcohol resistant foam, dry chemical or carbon dioxide

water jets

If heated or in cases of fire, pressure in a vessel will increase and container may burst.

Promptly isolate and secure the scene, remove all unnecessary and untrained persons from the vicinity if there is a fire.

Stop leak if safe to do so. Adopt best manual handling considerations when handling, carrying and dispensing.

Use appropriate containment to avoid environmental contamination

Collect as much as possible in clean container for reuse or disposal; Remove contaminated material to safe location for subsequent disposal

Use personal protective equipment as required. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Remove contaminated clothing

Keep container tightly closed, in a cool, well ventilated place

Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Remove contaminated clothing

Provide adequate ventilation. Avoid inhalation of vapours and spray/mists. Observe any occupational exposure limits for the product or ingredients.

The correct choice of protective gloves depends upon the chemicals being handled, and the conditions of work and use. Most gloves provide protection for only a limited time before they must be discarded and replaced (even the best chemically resistant gloves will break down after repeated chemical exposures). Gloves should be chosen in consultation with the supplier / manufacturer and taking account of a full assessment of the working conditions. Breakthrough time data are generated by glove manufacturers under laboratory test conditions and represent how long a glove can be expected to provide effective permeation resistance. It is important when following breakthrough time recommendations that actual workplace conditions are taken into account. Consult with your glove supplier for up-to-date technical information.

If contact is likely, safety glasses are recommended.

No special requirements under ordinary conditions of use and with adequate ventilation. In case of insufficient ventilation, wear suitable respiratory equipment. The correct choice of respiratory protection depends upon the chemicals being handled, the conditions of work and use, and the condition of the respiratory equipment. Safety procedures should be developed for each intended application. Respiratory protection equipment should therefore be chosen in consultation with the supplier/manufacturer and with a full assessment of the working conditions.

Wear appropriate clothing as protection against splashing.

Considered stable under normal conditions.

No specific test data available for this product. Refer to Conditions to avoid and Incompatible materials for additional information.

No hazardous reactions known if used for its intended purpose

Avoid heat, flames and other sources of ignition.

Oxidising agent

Under normal conditions of storage and use, hazardous decomposition products should not be produced. See Section 5.2