Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- VG1072
- Product Code
- 73457
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
Viscosity modifier additive for lubricating oil
Uses advised against
This material should not be used for any other purpose than that recommended without expert advice.
Manufacturers & Suppliers
INFINEUM NETHERLANDS B.V.
manufacturer
Herikerbergweg 238 Luna Arena, 1101 CM Amsterdam, The Netherlands
+44 1235 549501
http://www.infineum.com
Emergency Contacts
Emergency Contact
04-4274.4690
Emergency Contact
+33-4.4274.4690
Emergency Contact
0221-7499 3355
Emergency Contact
+49-221-7499 3355
Emergency Contact
019-2150 221
Emergency Contact
+39 019-2150 221
Emergency Contact
01235 549777
Emergency Contact
+44 1235 549777
Emergency Contact
070 245 245
Emergency Contact
+32 70 245 245
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
GHS Pictograms
Still copying SDS data manually?Free
You don't have to. NextSDS reads this SDS and adds the information to your library automatically.
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| lubricating oils (petroleum), C15-30, hydrotreated neutral oil-based EC: 276-737-9 | --- | 30 - 50% | Yes |
| distillates (petroleum), hydrotreated heavy paraffinic EC: 265-157-1 | --- | 30 - 50% | Yes |
| lubricating oils (petroleum), C20-50, hydrotreated neutral oil-based EC: 276-738-4 | --- | 30 - 50% | Yes |
First Aid Measures
Emergency procedures for chemical exposure incidents
If unconscious, place in recovery position and seek medical advice. If symptoms persist, call a physician.
Take off contaminated clothing and shoes immediately. Wash off with soap and plenty of water. If symptoms persist, call a physician. In case of burns apply cold water until pain subsides then seek medical advice.
Flush eyes with water as a precaution. Remove contact lenses. Protect unharmed eye. Keep eye wide open while rinsing. If eye irritation persists: Get medical advice/ attention.
Clean mouth with water and drink afterwards plenty of water. Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician.
Immediate Medical Attention
No hazards which require special first aid measures.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish flames.
Do NOT use water jet.
Not classified as flammable or combustible, but will combust if ignited.
Standard procedure for chemical fires. Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.
Firefighter Protection
In the event of fire, wear self-contained breathing apparatus.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Avoid contact with spilled material. Do not touch or walk through spilled material.
Wipe up with absorbent material (e.g. cloth, fleece).
Dyke far ahead of liquid spill for later recovery and disposal. Recover by pumping or with suitable absorbent
Prevent entry into waterways, sewers, basements or confined areas. Prevent further leakage or spillage if safe to do so.
Recover by pumping or with suitable absorbent. Wipe up with absorbent material (e.g. cloth, fleece).
Materials: absorbent material (e.g. cloth, fleece)
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Smoking, eating and drinking should be prohibited in the application area. Take precautionary measures against static discharges. Dispose of rinse water in accordance with local and national regulations. Ensure all equipment is electrically grounded before beginning transfer operations. For safety reasons free water must be avoided when product is handled above 95degC. Free water is always detrimental to product quality.
Keep container tightly closed in a dry and well-ventilated place.
Smoking, eating and drinking should be prohibited in the application area.
Normal measures for preventive fire protection. Take precautionary measures against static discharges.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
No Exposure Scenario annex is attached to this safety data sheet. It is a non-classified mixture containing hazardous substances as detailed in Section 3; relevant information from Exposure Scenarios for the hazardous substances contained have been integrated into the core sections 1-16 of this SDS. No special requirements under ordinary conditions of use and with adequate ventilation.
Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion, and the contact time. For prolonged or repeated contact use protective gloves. The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it.
Safety glasses. The applicable European standard can be found in EN 166.
No personal respiratory protective equipment normally required. The applicable European standard can be found in EN 140, EN 137, EN 143, EN 14387.
Long sleeved clothing. The applicable European standard can be found in EN 14605.
No Exposure Scenario annex is attached to this safety data sheet. It is a non-classified mixture containing hazardous substances as detailed in Section 3; relevant information from Exposure Scenarios for the hazardous substances contained have been integrated into the core sections 1-16 of this SDS. Prevent entry into waterways, sewers, basements or confined areas. Do not flush into surface water or sanitary sewer system. Prevent further leakage or spillage if safe to do so. Try to prevent the material from entering drains or water courses. If the product contaminates rivers and lakes or drains inform respective authorities.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable under recommended storage conditions.
No dangerous reaction known under conditions of normal use.
No hazards to be specially mentioned.
Excessive heat.
Strong oxidizing agents
No decomposition if used as directed.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
12.1 Toxicity
No data is available on the product itself.
12.1 Toxicity
12.2 Persistence and degradability
12.3 Bioaccumulative potential
12.4 Mobility in soil
12.5 Results of PBT and vPvB assessment
The product and its components (lubricating oils (petroleum), C15-30, hydrotreated neutral oil-based; distillates (petroleum), hydrotreated heavy paraffinic; lubricating oils (petroleum), C20-50, hydrotreated neutral oil-based) are not considered to be PBT or vPvB.
12.6 Endocrine Disrupting Properties
No data is available on the product itself.
12.7 Other adverse effects
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
Dispose of contents/ container to an approved waste disposal plant.
Disposal recommendations based on material as supplied, Disposal must be in accordance with applicable laws and regulations, and material characteristics at time of disposal
Waste Codes
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- UN Number
- UN3257
- Shipping Name
- Elevated Temperature Liquid, n.o.s. (Aryl polyolefin)
- Transport Class
- 9
- Packing Group
- III
The above classification applies if the product is offered for transport at a temperature equal or greater than 100 deg. C (212 deg. F). If the product is offered for transport at less than 100 deg. C (212 deg. F), the transport classification is Not Regulated.
The above classification applies if the product is offered for transport at a temperature equal or greater than 100 deg. C (212 deg. F). If the product is offered for transport at less than 100 deg. C (212 deg. F), the transport classification is Not Regulated.
Product classified as UN 3257 is forbidden by air transport but the product may be transported by air if its temperature is less than 100 deg. C (212 deg. F). If the product is offered for transport at less than 100 deg. C (212 deg. F), the transport classification is Not Regulated.
Regulatory Information
Chemical regulations, safety assessments, and compliance status
Risk classification according to VbF: Exempt. Major Accident Hazard: 2012/18/EU. Legislation: Not applicable.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for VG1072?
The signal word is no signal word.
What is the physical form of VG1072?
VG1072 is a liquid with clear color. It has hydrocarbon-like odor.
What is VG1072 used for?
Viscosity modifier additive for lubricating oil
What is the melting point of VG1072?
The melting point is not determined and the boiling point is not determined.