DG1034

No specific first aid measures are required. If exposed to excessive levels of material in the air, move the exposed person to fresh air.

Symptoms: coughing or respiratory discomfort

Wash skin with water immediately and remove contaminated clothing and shoes. To remove the material from skin, apply a waterless hand cleaner, mineral oil, or petroleum jelly. Then wash with soap and water. Discard contaminated clothing and shoes or thoroughly clean before reuse.

Symptoms: Contact with the skin may cause an allergic skin reaction. Symptoms may include pain, itching, discoloration, swelling, and blistering.

No specific first aid measures are required. As a precaution, remove contact lenses, if worn, and flush eyes with water.

Symptoms: Not expected to cause prolonged or significant eye irritation.

No specific first aid measures are required. Do not induce vomiting.

Symptoms: Not expected to be harmful if swallowed.

Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish flames.

A complex mixture of airborne solids, liquids, and gases including carbon monoxide, carbon dioxide, and unidentified organic compounds will be evolved when this material undergoes combustion.

For fires involving this material, do not enter any enclosed or confined fire space without proper protective equipment, including self-contained breathing apparatus.

Eliminate all sources of ignition in vicinity of spilled material. Refer to Sections 5 and 8 for more information.

Stop the source of the release if you can do it without risk. Contain release to prevent further contamination of soil, surface water or groundwater.

Clean up spill as soon as possible, observing precautions in Exposure Controls/Personal Protection. Use appropriate techniques such as applying non-combustible absorbent materials or pumping.

Materials: non-combustible absorbent materials

Do not get in eyes, on skin, or on clothing. If this material is heated above 49°C (120°F) thermal burns can result from accidental contact with skin or eyes. Wear appropriate personal protective equipment if engineering controls or work practices are not adequate to prevent contact. Some heated materials may release fumes that are unpleasant and produce nausea and irritation of the eyes and respiratory tract. Use in a well-ventilated area. Do not taste or swallow. Wash thoroughly after handling.

The recommended long-term (2 weeks or more) storage temperature is ambient to 45°C (113°F) maximum. Storage temperatures for up to 2 weeks should not exceed 66°C (150°F).

Wash thoroughly after handling.

Electrostatic charge may accumulate and create a hazardous condition. Bonding and grounding may be necessary. Do not expose containers to heat, flame, sparks, static electricity, or other sources of ignition.

Use in a well-ventilated area.

Suggested materials for protective gloves include: Nitrile Rubber, Silver Shield, Viton.

No special eye protection is normally required. Where splashing is possible, wear safety glasses with side shields as a good safety practice.

No respiratory protection is normally required. If user operations generate an oil mist, determine if airborne concentrations are below the occupational exposure limit for mineral oil mist. If not, wear an approved respirator that provides adequate protection from the measured concentrations of this material. For air-purifying respirators use a particulate cartridge.

Wear protective clothing to prevent skin contact. Selection of protective clothing may include gloves, apron, boots, and complete facial protection depending on operations conducted.

See relevant Community environmental protection legislation or the Annex, as applicable.

This material is considered stable under normal ambient and anticipated storage and handling conditions of temperature and pressure.

May react with strong acids or strong oxidizing agents, such as chlorates, nitrates, peroxides, etc.

Hazardous polymerization will not occur.

Do not exceed handling and storage temperatures listed in MSDS Section 7 (Handling and Storage).

Not applicable

Alkyl Mercaptans (See Section 7), Hydrogen Sulfide (See Section 7)

Use material for its intended purpose or recycle if possible.

This material, if it must be discarded, may meet the criteria of a hazardous waste as defined by international, country, or local laws and regulations.