HyVolt I

Move to fresh air. Oxygen or artificial respiration if needed. Do not use mouth-to-mouth method if victim inhaled the substance. Induce artificial respiration with the aid of a pocket mask equipped with a one-way valve or other proper respiratory medical device.

Symptoms: Coughing, discomfort in the chest.

Wash contact areas with soap and water. Remove contaminated clothing. Launder contaminated clothing before reuse.

Symptoms: Defatting of the skin, allergic skin reaction.

Flush thoroughly with water.

Symptoms: Irritation.

Do NOT induce vomiting. If vomiting occurs naturally, have victim lean forward to reduce risk of aspiration. Call a poison control center immediately.

Halon, Dry chemicals, Foam, Carbon dioxide (CO2), Water spray or fog.

Do not use a solid water stream as it may scatter and spread fire. Do not use water jet as an extinguisher, as this will spread the fire.

No unusual fire or explosion hazards noted.

Cool containers exposed to flames with water until well after the fire is out.

Keep unnecessary personnel away. Wear appropriate protective equipment and clothing during clean-up. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth or absorbent material then place into containers. Following product recovery, flush area with water.

Prevent further leakage or spillage if safe to do so. Prevent entry into waterways, sewer, basements or confined areas. Avoid discharge to the aquatic environment. Contact local authorities in case of spillage to drain/aquatic environment.

Absorb in vermiculite, dry sand or earth or absorbent material then place into containers. Following product recovery, flush area with water. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: vermiculite, dry sand, earth, absorbent material, cloth, fleece

DO NOT handle, store or open near an open flame, sources of heat or sources of ignition. Protect material from direct sunlight. Do not breathe dust/fume/gas/mist/vapors/spray. Wash hands after handling and before eating. Do not get this material in contact with eyes. Avoid contact with skin. Avoid prolonged exposure. All handling to take place in well-ventilated area. Shower after work. Remove and wash contaminated clothing promptly.

Store locked up. Keep away from heat, sparks and open flame. Store in a well-ventilated place. Use care in handling/storage. Protect material from direct sunlight.

Wash hands after handling and before eating. Shower after work. Remove and wash contaminated clothing promptly.

DO NOT handle, store or open near an open flame, sources of heat or sources of ignition. Keep away from heat, sparks and open flame.

Stable.

The product is stable and non-reactive under normal conditions of use, storage and transport.

Hazardous polymerization does not occur.

Heat, flames and sparks. Avoid temperatures exceeding the flash point.

Strong oxidizing agents.

Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low molecular weight hydrocarbons.

Dispose of in accordance with local regulations.

Disposal recommendations are based on material as supplied. Disposal must be in accordance with current applicable laws and regulations, and material characteristics at time of disposal.