OCC Pulp Composites

Move affected person to fresh air and keep warm and at rest in a position comfortable for breathing. Get medical attention if any discomfort continues.

Wash skin thoroughly with soap and water. Use suitable lotion to moisturise skin.

Symptoms: May cause skin sensitisation or allergic reactions in sensitive individuals.

Do not rub eye. Rinse with copious quantities of water and seek medical attention if irritation persists.

Rinse mouth thoroughly with water. Get medical attention if any discomfort continues.

This product is non-combustible. No specific extinguishing media is needed.

Irritating gases or vapours. Carbon monoxide (CO). Nitrous gases (NOx). Hydrogen bromide (HBr). Hydrogen chloride (HCl).

In case of spills, beware of slippery floors and surfaces.

Do not discharge into drains or watercourses or onto the ground.

Remove spillage with vacuum cleaner or collect with a shovel and broom, or similar. Flush contaminated area with plenty of water.

Materials: suitable waste disposal containers

Do not eat, drink and smoke in work areas; wash hands after use; remove contaminated clothing and protective equipment before entering eating areas.

Store in a dry covered area.

Do not eat, drink and smoke in work areas; wash hands after use; remove contaminated clothing and protective equipment before entering eating areas.

Minimise airborne dust generation. Use process enclosures, local exhaust ventilation or other engineering controls to keep airborne levels below specified exposure limits. If user operations generate dust, fumes or mist, use ventilation to keep exposure to airborne particles below the exposure limit. Apply organisational measures, e.g. by isolating personnel from dusty areas. Provide adequate ventilation. Avoid inhalation of vapours. Observe any occupational exposure limits for the product or ingredients.

Chemical-resistant, impervious gloves complying with an approved standard should be worn if a risk assessment indicates skin contact is possible. It is recommended that gloves are made of the following material: Nitrile rubber.

Eyewear complying with an approved standard should be worn if a risk assessment indicates eye contact is possible. The following protection should be worn: Chemical splash goggles or face shield. Contact lenses should not be worn when working with this product.

Local ventilation to control airborne dust levels below occupational exposure limits is recommended. In case of exposure, where engineering controls are insufficient, the use of Respiratory Protective Equipment (RPE) is recommended. A risk assessment process must be followed to ensure adequate protection from the airborne dust. The type of RPE must suit the work situation and the specific requirements of the wearer. Other environmental conditions should also be considered. The minimum "Assigned Protection Factor" (APF) required will depend on the measured or predicted occupational exposure levels divided by the OEL detailed in section 8.1. Filters specified as FFP2 and P2 have an APF of 10. Correctly fitted, these would reduce the exposure to the wearer down to one tenth of the working atmosphere. Depending on the assessment of the exposure, a lesser or higher efficiency of filter may be required. The manufacturer's instructions and regulatory guidance regarding duration of use and correct fitting should be followed. The wearer of the selected RPE should receive training before use.

Wear apron or protective clothing in case of contact.

Stable at normal ambient temperatures and when used as recommended.

There are no known reactivity hazards associated with this product.

Not applicable.

Avoid heat. Avoid freezing.

No specific material or group of materials is likely to react with the product to produce a hazardous situation.

Thermal decomposition or combustion products may include the following substances: Irritating gases or vapours. Carbon monoxide (CO). Nitrous gases (NOx). Hydrogen bromide (HBr). Hydrogen chloride (HCl).

Recycling and disposal of packaging should be carried out by an authorised waste management company.

Where possible, recycling is preferable to disposal. Can be disposed of in compliance with local regulations.