AUTOL TOP 2000

If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing. Seek medical attention if problems persist.

After contact with skin, first remove product with a dry cloth and then wash the skin with plenty of water. In case of skin reactions, consult a physician.

Immediately flush eyes with plenty of flowing water for 10 to 15 minutes holding eyelids apart. Remove contact lenses, if present and easy to do. Continue rinsing. Subsequently consult an ophthalmologist.

Symptoms: Causes serious eye irritation.

Rinse mouth immediately and drink plenty of water. Never give anything by mouth to an unconscious person. Do not induce vomiting. Seek medical attention.

Water spray jet, extinguishing powder, foam, Sand, carbon dioxide.

Full water jet

May form dangerous gases and vapours in case of fire. Danger of formation of toxic pyrolysis products.

Co-ordinate fire-fighting measures to the fire surroundings.

Avoid breathing mist/vapours/spray. Avoid contact with the substance. If possible, eliminate leakage. Keep unprotected people away.

Collect mechanically (use only explosion-proof equipment when pumping out).

Do not allow to enter into ground-water, surface water or drains.

Absorb with liquid-binding material and place in closed containers for disposal. Collect mechanically.

Materials: liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents)

Provide adequate ventilation, and local exhaust as needed. Avoid breathing mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Wear appropriate protective equipment.

Keep container tightly closed and in a well-ventilated place. Keep container dry. Keep only in the original container. Protect from heat and direct sunlight. Store containers in upright position. Protect from frost.

Do not eat, drink or smoke when using this product. Wash hands thoroughly after handling. Take off contaminated clothing and wash it before reuse.

Keep away from heat.

Provide for good ventilation or exhaust system or work with completely self-contained equipment.

Protective gloves according to EN 374. Glove material: Nitrile rubber. Breakthrough time: 240 min. Layer thickness: 0.4 mm. Observe glove manufacturer's instructions concerning penetrability and breakthrough time.

Tightly sealed goggles according to EN 166.

In case of inadequate ventilation wear respiratory protection. The filter class must be suitable for the maximum contaminant concentration (gas/vapour/aerosol/particulates) that may arise when handling the product.

Wear suitable protective clothing.

Refer to "6.2 Environmental precautions".

Stable under recommended storage conditions.

Refer to subsection "Possibility of hazardous reactions".

No hazardous reaction when handled and stored according to provisions.

Keep away from heat sources, sparks and open flames. Protect from direct sunlight. Protect from frost.

Strong oxidizing agents

No decomposition when used properly. > 240 °C

Dispose of waste according to applicable legislation.

Do not dispose of with household waste.